Results 101 to 110 of about 81,805 (205)
Laboratory Evaluation of Foamed Warm Mix Asphalt
University Transportation Centers Program2014PDFTech ReportBennert, ThomasRutgers University. Center for Advanced Infrastructure and TransportationNew Jersey. Department of Transportation. Bureau of MaterialsUnited States.
core
Effective Shoulder Design and Maintenance: TR-531, 2007 [PDF]
, 2007 Granular shoulders are an important element of the transportation system and are constantly subjected to performance problems due to wind- and water-induced erosion, rutting, edge drop-off, and slope irregularities.
core
, 2019 The objective of this study is to characterize the foamed asphalt binders prepared using different combinations of physical and chemical foaming agents.
You, Zhanping +4 more
core +1 more source
Asphalt technology and construction practices : instructor s guide/ The Asphalt Institute
xxx, page A 1-M 21, 27 ...
The Asphalt Institute
core
A Study Of In-Place Rutting Of Asphalt Pavements [PDF]
The objective of this study was to evaluate in-place pavements experiencing rutting and pavements experiencing no rutting to begin to classify asphalt mixtures that should perform satisfactorily and those that would likely rut under traffic.
Brown, E.R., Cross, Stephen A.
core
InfrastructuresThis paper presents gradations of both Hot In-place Recycling (HIR) and Cold In-place Recycling (CIR) and analysis of cores collected from CIR/Hot Mix Asphalt (HMA) overlay sections in Iowa.
Hosin Lee +3 more
doaj +1 more source
Influence of Waste Engine Oil Addition on the Properties of Zeolite-Foamed Asphalt. [PDF]
Materials (Basel), 2019 Woszuk A, Wróbel M, Franus W.
europepmc +1 more source
Use of Foamed Asphalt and Foamed Bitumen for Recycled Asphalt Mixtures: A Review
Civil Engineering and ArchitectureLuis Villegas +5 more
openaire +1 more source
Influence of foaming water content and mixing temperature on foam asphalt mixtures
, 2021 High air void content and inadequate coating of coarse aggregate particles are major challenges in the application of warm mix asphalt (WMA) using foam asphalt technology. Aggregate particle coating has significant influence on air voids content in foam asphalt mixture and is directly dependent on the volume of foam bitumen in the mixture and ...
openaire +1 more source
Introduction of recycled polyurethane foam in mastic asphalt
Građevinar, 2018 The aim of this paper is to analyse the suitability of recycled polyurethane (PU) foam as a binder modifier in mastic asphalts (MA). The results show that harder bitumen is achieved with an increasing percentage of PU, up to 5 %, when the workability of the sample becomes poor. A MA mix with a 4 % of PU in bitumen was manufactured.
Miguel Ángel Salas +1 more
openaire +2 more sources