Results 101 to 110 of about 81,804 (207)

Design of Large Stone Asphalt Mixes to Minimize Rutting [PDF]

Rutting of heavy duty asphalt pavements has been increasingly experienced in recent years. This phenomenon is primarily resulting from high tire pressures and increased wheel loads.
Kandhal, Prithvi S.
core  

Optimizing Foamed Bitumen Mixtures: AI-Based Determination of Ideal RAP and FBC Percentages Using HWTT and ITS Data

Applied Sciences
The combination of reclaimed asphalt pavement (RAP) and foamed bitumen content (FBC) in bitumen mixtures presents a viable and economically advantageous approach to asphalt pavement construction. This investigation delves into the optimal combinations of
Ali Saleh, László Gáspár
doaj   +1 more source

Laboratory Evaluation of Foamed Warm Mix Asphalt

University Transportation Centers Program2014PDFTech ReportBennert, ThomasRutgers University. Center for Advanced Infrastructure and TransportationNew Jersey. Department of Transportation. Bureau of MaterialsUnited States.

core  

Effective Shoulder Design and Maintenance: TR-531, 2007 [PDF]

, 2007
Granular shoulders are an important element of the transportation system and are constantly subjected to performance problems due to wind- and water-induced erosion, rutting, edge drop-off, and slope irregularities.

core  

Characterizations of foamed asphalt binders prepared using combinations of physical and chemical foaming agents

, 2019
The objective of this study is to characterize the foamed asphalt binders prepared using different combinations of physical and chemical foaming agents.
You, Zhanping, Zhang, Ran, You, Lingyun, Yin, Huiming, Hasan, Mohn Rosli Mohd   +4 more
core   +1 more source

Asphalt technology and construction practices : instructor s guide/ The Asphalt Institute

xxx, page A 1-M 21, 27 ...
The Asphalt Institute
core  

Characteristics of water-foamed asphalt mixture under multiple freeze-thaw cycles: Laboratory evaluation

, 2018
A major concern with the application of water-foamed asphalt mixtures is the possible performance degradation caused by the presence of inclusion water during production.
You, Zhanping, You, Lingyun, Schiltz, Meghan, Wang, Jiaqing, Dai, Qingli, Guo, Shuaicheng   +5 more
core   +1 more source

A Study Of In-Place Rutting Of Asphalt Pavements [PDF]

The objective of this study was to evaluate in-place pavements experiencing rutting and pavements experiencing no rutting to begin to classify asphalt mixtures that should perform satisfactorily and those that would likely rut under traffic.
Brown, E.R., Cross, Stephen A.
core  

Impacts of Milled Aggregate Gradations and Foamed Asphalt Contents of Cold In-Place Recycling Layer on the Performance of Asphalt Overlays

Infrastructures
This paper presents gradations of both Hot In-place Recycling (HIR) and Cold In-place Recycling (CIR) and analysis of cores collected from CIR/Hot Mix Asphalt (HMA) overlay sections in Iowa.
Hosin Lee, Byungkyu Moon, Ashley Buss, Charles T. Jahren   +3 more
doaj   +1 more source

Influence of Waste Engine Oil Addition on the Properties of Zeolite-Foamed Asphalt. [PDF]

Materials (Basel), 2019
Woszuk A, Wróbel M, Franus W.
europepmc   +1 more source