Results 71 to 80 of about 570,562 (302)
Measuring the radial collision force between the steam generator tube (SGT) and the tube support plate (TSP) is essential to assess the fretting damage of the SGT. In order to measure the radial collision force, a novel miniaturized force sensor based on
Peijian Huang +4 more
doaj +1 more source
A force sensor system was developed to give real-time visual feedback on a range of force. In a prospective observational cross-section study, twenty-two anaesthesia nurses applied cricoid pressure at a target range of 30-40 Newtons for 60 seconds in ...
Hwan Ing Hee +4 more
doaj +1 more source
New fabrication technique for highly sensitive qPlus sensor with well-defined spring constant
A new technique for the fabrication of highly sensitive qPlus sensor for atomic force microscopy (AFM) is described. Focused ion beam was used to cut then weld onto a bare quartz tuning fork a sharp micro-tip from an electrochemically etched tungsten ...
Huff, Taleana +7 more
core +1 more source
Peptide‐based ligand antagonists block a Vibrio cholerae adhesin
The structure of a peptide‐binding domain of the Vibrio cholerae adhesin FrhA was solved by X‐ray crystallography, revealing how the inhibitory peptide AGYTD binds tightly at its Ca2+‐coordinated pocket. Structure‐guided design incorporating D‐amino acids enhanced binding affinity, providing a foundation for developing anti‐adhesion therapeutics ...
Mingyu Wang +9 more
wiley +1 more source
Design and Test of a New Inductive Force Sensor
The currently accepted interval of weekly cast changes in the treatment of clubfeet seems unsubstantiated. A force sensor is needed to determine the adaptation rate of a clubfoot to establish what cast change interval would be most effective and ...
Robert Bram Giesberts +2 more
doaj +1 more source
The paper deals with the issue of calibration of an analogue force sensor with a voltage output. For measurement, the force sensor uses a deformation member with a tensometric bridge and a measuring amplifier. This measuring chain must be used for force measurement, but the measurement uncertainty of this measuring chain is not known. Force sensors are
Tatiana Kelemenova, Michal Kelemen
openaire +1 more source
Disordered but rhythmic—the role of intrinsic protein disorder in eukaryotic circadian timing
Unstructured domains known as intrinsically disordered regions (IDRs) are present in nearly every part of the eukaryotic core circadian oscillator. IDRs enable many diverse inter‐ and intramolecular interactions that support clock function. IDR conformations are highly tunable by post‐translational modifications and environmental conditions, which ...
Emery T. Usher, Jacqueline F. Pelham
wiley +1 more source
Universal Vectorial and Ultrasensitive Nanomechanical Force Field Sensor
Miniaturization of force probes into nanomechanical oscillators enables ultrasensitive investigations of forces on dimensions smaller than their characteristic length scale.
A Cleland +48 more
core +3 more sources
Hybrid Position and Force Control Without Force Sensor
Generally, hybrid control is realized by sensor signal feedback of position and force. However, some robot manipulators do not have a force sensor due to the environment. Moreover, a precise force sensor is very expensive. In order to overcome these problems, we propose the estimation system of reaction force without using a force sensor.
Kiyoshi OHISHI +2 more
openaire +2 more sources
Integration of circadian and hypoxia signaling via non‐canonical heterodimerization
CLOCK, BMAL1, and HIFs are basic helix‐loop‐helix and Per‐Arnt‐Sim domain (bHLH‐PAS) proteins, which function as transcription factors. bHLH‐PAS proteins are designated in two classes. Many class I proteins are regulated by environmental signals via their PAS domains, but such signals have not been identified for all.
Sicong Wang, Katja A. Lamia
wiley +1 more source

