Results 21 to 30 of about 382,579 (216)
Estimation of slope stability using ensemble-based hybrid machine learning approaches
Frontiers in MaterialsMining is one of the most daunting occupations gain the sector since it entails risk at any point in the operation. In its operation, the main focus is on slope stability.
Prashanth Ragam +6 more
semanticscholar +1 more source
Screening of microorganisms from pineapple waste for fructooligosaccharides production
IOP Conference Series: Materials Science and Engineering, 2020 Fructooligosaccharides (FOS) are one of the well-known low caloric value sweeteners with prebiotic properties that promote positives effects on consumer’s health.
L. Tan +4 more
semanticscholar +1 more source
Slope Stability Analysis of Granitic Residual Soil Using SLOPE/W, Resistivity and Seismic
International journal of engineering and technology, 2018 There are many factors that influence slope failure such as natural disasters and human activities. Amongst the major causes are the rise of groundwater and infiltration of prolonged and antecedent rainfalls.
R. Omar +6 more
semanticscholar +1 more source
Thermal Stress Simulation on a Stainless-steel Submersible Water Heater design
IOP Conference Series: Materials Science and Engineering, 2020 A new design of immersion heater is proposed for common household use and is checked for stress induced due to heating and the corresponding factor of safety (FOS).
S. Singh +5 more
semanticscholar +1 more source
Study on Section Selection of Super Large Oil Storage Tunnel Based on Strength Reduction Method
IOP Conference Series: Materials Science and Engineering, 2020 To study the section selection of super large oil storage tunnel could help make full use of underground space and arrange tunnels reasonably. The stability of tunnel with three different section (horseshoe section, circular section, elliptic arch ...
Liang Xiang +4 more
semanticscholar +1 more source
Numerical study of slope protected by rockfill and shredded tyre mixture gabion wall
IOP Conference Series: Materials Science and Engineering, 2020 Abundance of discarded scrap tyre in Malaysia demand diverse recycling products, in order to reduce its environmental pollutions and simultaneously the negative aftermaths to society and future generation.
A. C. Ainul Mardziah, A. Amizatulhani
semanticscholar +1 more source
Advanced Healthcare Materials, EarlyView.We measure the cell‐specific responses of administering infusible ECM (iECM) in acute myocardial infarction (MI) across multiple timepoints. Using single‐nucleus RNA sequencing and spatial transcriptomics, we measure macrophage activation, fibroblast remodeling, increased vascular development, lymphangiogenesis, cardioprotection, and neurogenesis ...
Joshua M. Mesfin +18 more
wiley +1 more source
Enumeration of probiotic strains from synbiotic samples produced by Myternak Trading
IOP Conference Series: Materials Science and Engineering, 2020 Natural defense mechanisms of animals by using probiotics, prebiotics, and synbiotics have been seen as an alternative way to improve animal health and to overcome the food-borne diseases among the livestock. This is as the previous use of antibiotics as
S. Gnanasekaran +4 more
semanticscholar +1 more source
Advanced Healthcare Materials, EarlyView.A two‐phase workflow (OFAT screening followed by central composite design) maps how processing variables tune PFCE‐PLGA nanoparticle size, dispersity, surface charge, loading, and 19F‐MRI signal. In situ, time‐resolved synchrotron SAXS tracks albumin‐corona growth on intact dispersions and reveals PFCE‐dependent adsorption pathways.
Joice Maria Joseph +11 more
wiley +1 more source
IOP Conference Series: Materials Science and Engineering, 2018 This paper describes the drying process conditions with the objective to minimise the negative effect over the final quality of the dry Yacon (mallanthus sonchifolius) for international commercialization.
S. P. Cuervo, A. Benitez, S. Castellanos
semanticscholar +1 more source