Results 231 to 240 of about 145,935 (291)

A Short‐Cut Design Approach to Evaluate Reboiler Designs in Vapor Recompression Scenarios

open access: yesChemie Ingenieur Technik, EarlyView.
A short‐cut model framework that incorporates mechanical vapor recompression (MVR) requirements into reboiler design is presented, which is particularly beneficial during early process development with limited data or initial feasibility assessments.
Franziska Lais   +2 more
wiley   +1 more source

Hydroprocessing of synthetic kerosene over a non‐sulphided Ni/Al2O3 catalyst: Impact of alcohols and ketones on alkene conversion

open access: yesThe Canadian Journal of Chemical Engineering, EarlyView.
Abstract Synthetic jet fuel containing non‐petroleum‐derived kerosene can be produced from synthetic kerosene obtained through processes that include a hydroprocessing step. The potential use of non‐sulphided (reduced) nickel supported on alumina (Ni/Al2O3) was evaluated as an alternative to sulphided catalysts to saturate alkenes in sulphur‐free ...
Garima Chauhan   +3 more
wiley   +1 more source

Modelling of continuous low‐temperature emulsion co‐polymerization in 3D‐printed reactor

open access: yesThe Canadian Journal of Chemical Engineering, EarlyView.
A kinetic model for the emulsion copolymerization of butyl acrylate/styrene at low temperatures is proposed and validated against experiments with a redox initiator system. The model was successfully transferred to a 3D‐printed tubular reactor and conversions of more than 80% and small particles sizes below 40 nm were observed.
Ferel Issa   +2 more
wiley   +1 more source

Supercritical water deasphalting and desulphurization of heavy fuel oil with comprehensive molecular‐level analysis and techno‐economic analysis

open access: yesThe Canadian Journal of Chemical Engineering, EarlyView.
Supercritical water deasphalting. Abstract The removal of sulphur from heavy fuel oil (HFO) is essential to address environmental concerns and comply with the stringent regulations imposed by the International Maritime Organization (IMO) in 2020. Previously, the acceptable limit for sulphur was 3.5 wt.%, but it was recently changed to 0.5 wt.%.
Biswajit Saha   +6 more
wiley   +1 more source

Synthesizing polyethersulphone membranes with hybrid iron/nickel nanoparticles for dyes removal: An efficient biogenesis approach

open access: yesThe Canadian Journal of Chemical Engineering, EarlyView.
Abstract Industrial wastewater contamination by azo dyes poses a significant environmental challenge. This study reports the green synthesis of bimetallic iron/nickel (Fe/Ni) nanoparticles using moringa leaf extract, which acted as both a reducing and capping agent, and their incorporation into polyethersulphone (PES) membranes to produce eco‐friendly ...
Qusay A. Almajras   +7 more
wiley   +1 more source

Home - About - Disclaimer - Privacy