Results 51 to 60 of about 710 (236)
Hydrogen‐Assisted Fracture of Iron‐Based Fe–Ni–Al Alloys
Principal relations and fracture mechanisms of single‐phase and precipitate‐strengthened Fe–Ni–Al alloys subjected to prior electrochemical hydrogen charging are identified. The mechanisms of hydrogen effect on strength and microhardness are discussed, including hydrogen‐induced increase in microhardness and the role of hydrogen in fracture behavior ...
Nataliya Yadzhak +3 more
wiley +1 more source
The temperature dependence of fatigue behavior in nickel‐based superalloys is investigated through high‐resolution measurements of plastic localization. While increasing temperature reduces localization and enhances fatigue performance in René 88DT, Inconel 718 exhibits a sharp degradation at intermediate temperature due to intensified slip ...
M. Calvat +5 more
wiley +1 more source
Parallel-connected uninterruptible power supply (UPS) systems have been used to maintain power supply to the critical load in order to increase power capacity and system reliability.
Muhammad Ali +5 more
doaj +1 more source
Fractional Order PID Controlled PV Buck Boost Converter with Coupled Inductor
Buck-boost converter is a good interface between PV and the load. This paper deals with comparison between PI and FOPID controlled PV fed Buck Boost Converter with Coupled Inductor (PVBBCCI) systems. Open loop PVBBCCI system, closed loop PI controlled PVBBCCI and FOPID based PVBBCCI systems are designed, modeled and simulated using Simulink and their ...
Vanitha D, M. Rathinakumar
openaire +1 more source
Influence of Test Temperature and Test Frequency on Fatigue Life of Aluminum Alloy EN AW‐2618A
The influence of test temperature and test frequency on the fatigue life of EN AW‐2618A is investigated. High‐cycle fatigue tests are performed at different test temperatures and frequencies on the 1000 h/230°C overaged state. Both test parameters reduce fatigue life due to time‐dependent damage mechanisms.
Ying Han +5 more
wiley +1 more source
This paper focuses on the fractional-order modeling and analysis of single-phase quasi-Z-source rectifier (qZSR), aims to extend the single-phase qZSR from integer-order domain to fractional-order domain. Additionally, it has been demonstrated explicitly
Xiaoquan Zhu, Ziwen Chen, Bo Zhang
doaj +1 more source
Precipitation Simulations of the O‐Phase in Ti2AlNb Alloys Processed by Laser Powder Bed Fusion
Simulated and experimental evolution of the O‐phase volume fraction during postprocessing of a Ti‐21Al‐25Nb (at.%) alloy processed by laser powder bed fusion. With results of sensitivity to input parameters from a thorough and quantified analysis, the interfacial energy matrix/precipitate is the most relevant input parameter for the simulation of the O‐
Silvana Tumminello +7 more
wiley +1 more source
Titanium Suboxides Responsible for Electronic Anomaly Near Room Temperature in the Ti3C2Tx MXene
Our multi‐technique study reveals that the near‐room‐temperature anomaly in Ti3C2Tx MXene is linked to titanium suboxide nanodomains, including Ti3O5, embedded within the MXene host. Their temperature‐driven transformation provides an alternative explanation to solvent‐ and swelling‐based models and offers new insight into the thermally activated ...
Bence G. Márkus +8 more
wiley +1 more source
Historical Foundation and Practical Guideline for Ferroelectric Switching Kinetic Studies
The P and U pulses in the conventional PUND measurements are not identical because of the interplay between switching current and the measurement circuit components. This circuit effect can lead to a shift in polarization transients and misinterpreted physics in the switching kinetics.
Yi Liang, Pat Kezer, John T. Heron
wiley +1 more source
Magnesium‐Based Transient Bioelectronics, Bio‐Optics and Bio‐Scaffolds
This paper reviews the state of the art and recent advances in magnesium‐based thin‐film, foils, and scaffolds for applications in transient bio‐optics, bioelectronics and tissue engineering. The design principles, fabrication methods, material properties, and integration strategies are discussed in detail.
Massimo Mariello, Yves Leterrier
wiley +1 more source

