Results 101 to 110 of about 4,261 (263)

Numerical and experimental study on P‐wave propagation across a rock joint with different orientations

Deep Underground Science and Engineering, EarlyView.
Joint orientation significantly affects P‐wave velocity, with the highest velocity at zero‐degree angles, decreasing to 30° as the angle increases. The velocity increases slightly from 30 to 45 degrees but sharply decreases from 45 to 90 degrees. Abstract Determination of the required parameters in different science contexts using the ultrasonic wave ...
Yaghoob Zarei, Mojtaba D. fallahi, Ali Uromeihy, Mohammad R. Nikoodel, Mohammad Fathollahy   +4 more
wiley   +1 more source

The impact of forced closure on proppant distribution of hydraulic fracturing in shale formations

Deep Underground Science and Engineering, EarlyView.
Research findings demonstrate that implementing forced closure within shale formations can remarkably mitigate proppant settlement, concurrently increasing the effective propped surface area from 29.74% to 38.68%. Abstract Forced closure is widely used in conventional oil and gas reservoirs to promote uniform proppant placement.
Tongxuan Gu, Hanyi Wang, Quan Gan, Shuang Zheng   +3 more
wiley   +1 more source

Instability mechanism and failure characteristics of underground cavern in block system under the action of seismic waves

Deep Underground Science and Engineering, EarlyView.
Seismic waves with tensile stress, high amplitude, and low frequency are most likely to trigger block instability and sliding. Blocks with a single sliding surface are more prone to movement than those with multiple constraints, and roof‐positioned blocks are especially vulnerable to slide.
Xiao Wang, Jinxiao Liu, Gaoshuo Zhang, Wenxin Li, Changdi He   +4 more
wiley   +1 more source

Study on the composite fracture characteristics of filling and reinforcing cracked rock mass after high temperature damage

Deep Underground Science and Engineering, EarlyView.
Cement infill shares compressive and shear stresses during loading, while interfacial friction hinders crack propagation and reduces stress concentration, improving the rock's load‐bearing capacity. Failure modes vary with crack inclination. Unfilled specimens show four modes.
Shihao Yuan, Qiang Sun, Jianjun Hu, Liwei Zhang, Jishi Geng   +4 more
wiley   +1 more source

Numerical simulation study on the evolution of the temperature field and frozen wall in fractured rock mass

Deep Underground Science and Engineering, EarlyView.
The evolution of the temperature field and frozen wall under different fracture conditions was examined by an artificial ground freezing‐based thermal‐hydraulic coupled model. It was observed that fracture inclination affects the interaction extent of freezing pipes and fracture, while phase transition extent is the dominant factor for heat transfer in
Chenyi Zhang, Tingting Luo, Tao Zhang, Tao Han, Xiaodong Zhao, Haipeng Li, Yanfei Ma, Faxing Zhang, Madhusudhan Bangalore Narasimha Murthy, Weihao Yang   +9 more
wiley   +1 more source

Modeling and experimental validation of bolt–grout bond–slip behavior for deep underground excavation support

Deep Underground Science and Engineering, EarlyView.
A novel shear‐lag model, validated by pull‐out tests, incorporates a constant bond stress stage to predict the complete load–displacement response of grouted rock bolts, providing a new tool for optimizing anchorage length and material toughness in deep underground engineering. Abstract The stability of rock masses in deep underground excavations, such
Wenhui Bian, Xiaohui He, Kexue Wang, Yufei Wu, Guoxin Wang, Shaochen Zhang, Jun Yang   +6 more
wiley   +1 more source

Analytical stress solution framework for lined compressed air energy storage chambers and its application to safe burial depth determination and supporting effectiveness evaluation

Deep Underground Science and Engineering, EarlyView.
An analytical framework delivers a closed‐form stress solution for lined compressed air energy storage chambers, enabling the determination of the minimum safe burial depth. The solution quantitatively evaluates lining support effectiveness, offering a reliable tool for chamber design and optimization.
Zeyuan Sun, Cheng Zhao, Jinquan Xing, Qinyuan Luo   +3 more
wiley   +1 more source

Advancing mine pillar design: Evaluating traditional methods and integrating AI for enhanced stability of pillars in the Great Dyke, Zimbabwe

Deep Underground Science and Engineering, EarlyView.
B1 is bord width 1, B2 is bord width 2, L is the pillar length, W is the pillar width, red color and letter A represent the pillars, and white color and number 1 represent excavated areas. Pstress is the average pillar stress; σv is the vertical component of the virgin stress, MPa; and e is the areal extraction ratio. e = B o B o + B P ${\rm{e}}=\frac{{
Tawanda Zvarivadza, Hendrik Grobler, Peter Apata Olubambi, Moshood Onifade, Manoj Khandelwal   +4 more
wiley   +1 more source

Experimental study on repair of fractured rock mass by microbial induction technology. [PDF]

R Soc Open Sci, 2019
Gao R, Luo Y, Deng H.
europepmc   +1 more source

Fracture evolution of a thick soft protection layer and the water inrush mechanism in overburden under longwall mining

Deep Underground Science and Engineering, EarlyView.
Through shear–tensile creep tests and viscoelastic modeling, the fracture evolution of thick soft protective layers is clarified. Results show thickness‐dependent rheological failure modes that govern four types of roof water inrush, providing a mechanism‐based framework for hazard prediction and control. Abstract In the Jurassic coal‐bearing strata of
Mengnan Liu, Wei Qiao, Xianggang Cheng, Xiangsheng Meng, Peichao Feng   +4 more
wiley   +1 more source