Results 251 to 260 of about 4,835,277 (359)

From Waste to Value: Conversion of Calcium Sulfate to Vaterite via Carbon Capture and Storage

open access: yesAdvanced Functional Materials, EarlyView.
This study introduces a new concept for carbon management that relies on the carbonation of industrial gypsum waste and yields phase‐pure vaterite at ambient conditions without any additives. The obtained vaterite is further shown to be a reactive material that develops compressive strength in aqueous suspensions like conventional cements.
Carlos Pimentel   +4 more
wiley   +1 more source

Development of the Canadian Eating Practices Screener for Adolescents to assess eating practices based on Canada's Food Guide 2019 recommendations. [PDF]

open access: yesInt J Behav Nutr Phys Act
Jacob R   +9 more
europepmc   +1 more source

The Effect of Amino Acids on the Formation of Amorphous Calcium Carbonate Nanoparticles

open access: yesAdvanced Functional Materials, EarlyView.
Biomineral formation often proceeds via the assembly of amorphous calcium carbonate (ACC) nanoparticles with narrow size distributions. Using in situ SAXS coupled to a stopped‐flow device, we follow synthetic ACC formation with a 10 ms time resolution and show that amino acids narrow the size distribution at low supersaturation, highlighting their key ...
Lucas Kuhrts   +10 more
wiley   +1 more source

Fully Bio‐Based Gelatin Organohydrogels via Enzymatic Crosslinking for Sustainable Soft Strain and Temperature Sensing

open access: yesAdvanced Functional Materials, EarlyView.
Enzymatically crosslinked gelatin‐based organohydrogels, fabricated through a fully bio‐based and scalable process, exhibit exceptional strain and temperature sensing capabilities with minimal interference from environmental humidity. These transparent, stretchable, and ionically conductive materials operate without synthetic fillers or dopants.
Pietro Tordi   +7 more
wiley   +1 more source

Interconnected Porous Hydrogels with Tunable Anisotropy Through Aqueous Emulsion Bioprinting

open access: yesAdvanced Functional Materials, EarlyView.
A 3D bioprintable microporous bioink is developed using an aqueous two‐phase system (ATPS) composed of extracellular matrix (ECM) mimetic biopolymers. The ATPS bioink enables the fabrication of interconnected porous architectures with up to 70% porosity, supporting long‐term cell viability and 3D cell alignment, enabling a simultaneous generation of ...
Hugo Edgar‐Vilar   +4 more
wiley   +1 more source

Home - About - Disclaimer - Privacy