Results 51 to 60 of about 13,370 (218)
Coarse‐grained (left) and atomistic (right) models of the shape memory polymer ESTANE ETE 75DT3 are shown schematically. The two representations bridge molecular detail and mesoscopic description. Both models capture shape memory behavior, linking segmental mobility and conformational relaxation of anisotropic chains to macroscopic recovery, and ...
Fathollah Varnik
wiley +1 more source
Gyrotron-type amplifiers are being developed for various applications requiring high power in the millimeter wavelength range. Calculations of the optimal designs of gyrotron traveling wave tubes (gyro-TWTs), presented in the article, were carried out using the Gyro-K computer program using a coordinate transformation technique, which made it possible ...
S. V. Kolosov, O. O. Shatilova
openaire +2 more sources
This work shows that the mechanical performance of multimaterial digital light processing (DLP) printed thermoset composites is governed by resin compatibility and interfacial design rather than spatial patterning alone. Brittle and ductile resin combinations produced premature interfacial failure, while graded interfaces and mechanically compatible ...
Ahmed M. H. Ibrahim +3 more
wiley +1 more source
Frequency multiplier for square waves
A Circuit for multiplying the frequency of square waves is reported. It uses a linear voltage-controlled astable multi-vibrator with feedback loops for maintaining the frequency multiplication ratio and the output mark/space ratio independent of variations in component values or device parameters.
openaire +1 more source
Shellac, a centuries‐old natural resin, is reimagined as a green material for flexible electronics. When combined with silver nanowires, shellac films deliver transparency, conductivity, and stability against humidity. These results position shellac as a sustainable alternative to synthetic polymers for transparent conductors in next‐generation ...
Rahaf Nafez Hussein +4 more
wiley +1 more source
Multianalyte, real‐time monitoring of bioprinted scaffolds remains challenging. Phosphorescence‐lifetime–based, optically responsive microparticles are embedded in diverse printable hydrogels (κ‐carrageenan, GelMA, PEGDA) to form biomaterial inks that report oxygen, glucose, lactate, and temperature.
Waqas Saleem +11 more
wiley +1 more source
Counterion Dependent Side‐Chain Relaxation Stiffens a Chemically Doped Thienothiophene Copolymer
Oxidation of a thienothiophene copolymer, p(g3TT‐T2), via different doping strategies and dopant molecules resulted in materials with similar oxidation levels and a high electrical conductivity of ≈100 S cm−1. However, mechanical properties varied significantly, with sub‐glass transition temperatures and elastic moduli spanning from –44°C to –3°C and ...
Mariavittoria Craighero +12 more
wiley +1 more source
Moiré band engineering in graphene/hexagonal boron nitride–based superlattices unlocks van Hove singularities (VHSs) for terahertz (THz) optoelectronics. Tuning the Fermi level near these singularities, associated with secondary neutrality points (SNPs), enhances the photothermoelectric response.
Leonid Elesin +16 more
wiley +1 more source
Speckle‐Engineered Upconversion Amplification in Nanoemulsion‐Templated Hydrogel Microdomes
Nanoemulsion‐confined PEGDA microdomes generate speckle‐like excitation fields that strongly amplify upconversion luminescence upon dehydration, enabling filter‐free visible readout with reversible on–off switching. DMD‐based lithography yields scalable, shape‐programmable arrays for moisture‐responsive displays and optical encryption.
Chaeyeong Ryu +13 more
wiley +1 more source
A fully transparent, all‐metal‐oxide neuromorphic transistor using a sodium‐embedded alumina (SEA) electrolyte is demonstrated. By precisely tuning the thermal annealing process, the chemical composition of the SEA layer is controlled, allowing for the deterministic realization of both short‐term and long‐term synaptic plasticity within the same device
Yonghyun Albert Kwon +7 more
wiley +1 more source

