Results 11 to 20 of about 554 (193)

A Design Study of 100GHz Band Local Oscillator System by Using Yig Oscillator [PDF]

open access: yesJournal of Astronomy and Space Sciences, 2003
In this paper, we make a design study for a local oscillator system of the 100 GHz band cosmic radio receiving system. We use the YIG oscillator with digital driver which is the main oscillator. This oscillator has a good frequency and phase stability at
Changhoon Lee   +6 more
doaj   +1 more source

The Design of Terahertz Monolithic Integrated Frequency Multipliers Based on Gallium Arsenide Material

open access: yesMicromachines, 2020
A global design method for a terahertz monolithic integrated frequency multiplier is proposed. Compared with a traditional independent design, the method in this paper adopts overall optimization and combines the device with the circuit design.
Jin Meng   +5 more
doaj   +1 more source

SCHOTTKY DIODE TRIPLER IN THE 3-MM WAVE RECEIVER FOR INVESTIGATION OF ATMOSPHERIC GASES

open access: yesRadio Physics and Radio Astronomy, 2015
A Schottky diode frequency tripler for the 3-mm receiver system designed for observation of ozone and carbon monoxide spectral lines at frequencies 110.836 and 115.271 GHz, respectively, is developed. The used varactor parameters are investigated and its
V. I. Piddyachiy
doaj   +1 more source

Image Enhancement Technique Using Manchester Coding and RF Tripler for 1-bit Bandpass Delta Sigma Direct Digital RF Transmitter

open access: yesIEEE Access, 2023
1-bit band-pass delta-sigma modulator (BP-DSM) can generate RF signal directly from 1-bit data stream in high dynamic range by oversampling technology without local oscillator (LO) and mixer, so the miniaturization of transmitter can be realized ...
Junhao Zhang, Noriharu Suematsu
doaj   +1 more source

Injection-Locked Frequency Sixtuplers in 90 nm CMOS by Using the Push-Push Doubler

open access: yesIEEE Access, 2023
This paper designs two single-stage LC-tank injection-locked frequency sixtuplers (ILFSs) fabricated in a 90 nm CMOS process and it describes the circuit design, operation principle, and measurement results of the ILFSs.
Sheng-Jen Cheng   +5 more
doaj   +1 more source

A Suspended Stripline Frequency Tripler Using a Left-Handed Nonlinear Transmission Line

open access: yesInternational Journal of Antennas and Propagation, 2015
A suspended stripline frequency tripler using a left-handed nonlinear transmission line (LH NLTL) is presented. The proposed tripler using the LH NLTL is composed of a series of varactor diodes, shunt inductances, and a high-pass filter implemented with ...
In Bok Kim   +3 more
doaj   +1 more source

Microwave Photonic Frequency Tripler Based on an Integrated Dual-Parallel Modulator Structure

open access: yesIEEE Photonics Journal, 2017
A new technique for tripling the frequency of a microwave signal is presented. It is based on an integrated dual-parallel Mach–Zehnder modulator, which generates two orthogonally polarised RF modulated optical signals with different modulation ...
Chongjia Huang   +2 more
doaj   +1 more source

Compact Wideband Antiparallel Diode Frequency Triplers Utilizing Planar Transitions

open access: yesInternational Journal of Antennas and Propagation, 2015
Two designs of frequency triplers, which use planar transitions as baluns and an antiparallel diode pair to achieve wide bandwidth, are presented.
Wahab Mohyuddin   +2 more
doaj   +1 more source

A Monolithic Dual-Band 77/94 GHz Transceiver Front-End With Shared Frequency Multiplier

open access: yesIEEE Access, 2019
This paper presents a monolithic dual-band 77/94 GHz transceiver front-end with shared frequency multiplier. The transceiver front-end consists of two transmitters and receivers, operating at 77 GHz and 94 GHz respectively to support dual-band operation.
Liang Chen, Lei Zhang, Yan Wang
doaj   +1 more source

Effect of Input LSB/USB Signal Imbalance on a 1-bit BPDSM Using Manchester Encoding and Tripler

open access: yesIEEE Access
Digital RF technology is necessary for the miniaturization of transmitters; however, its application to high-frequency bands is challenging due to the impractically high sampling frequencies required.
Yuki Fujiya   +3 more
doaj   +1 more source

Home - About - Disclaimer - Privacy