Journal of the Society of Materials Science, Japan, 1969 Kunio NISHIOKA, Kenji HIRAKAWA
openaire +2 more sources
Effects of Shot Peening on Fretting Fatigue Crack Initiation Behavior. [PDF]
Materials (Basel), 2019 Liu X, Liu J, Zuo Z, Zhang H.
europepmc +1 more source
The influence of fretting-corrosion on the fatigue strength of titanium alloys [PDF]
, 2006 The results of the executed researches of BT1-0, OT4, BT8, BT3-1 titanium alloys fretting-fatigue strength was represented. Influence of vibro–contact loading parameters, nature of the attended materials, level of initial strength and structure of alloys
Dukhota, A. I. +5 more
core
Numerical Investigation of 1 × 7 Steel Wire Strand under Fretting Fatigue Condition. [PDF]
Materials (Basel), 2019 Ahmad S +5 more
europepmc +1 more source
Selected fretting-wear-resistant coatings for titanium - 6-percent-aluminum - 4-percent-vanadium alloy [PDF]
A titanium - 6-percent-aluminum - 4-percent-vanadium alloy (Ti-6Al-4V) was subjected to fretting-wear exposures against uncoated Ti-6Al-4V as a baseline and against various coatings and surface treatments applied to Ti-6Al-4V.
Bill, R. C.
core +1 more source
Fretting Fatigue Experiment and Analysis of AlSi9Cu2Mg Alloy. [PDF]
Materials (Basel), 2016 Wang J +6 more
europepmc +1 more source
Analytical and experimental investigation of fatigue in a sheet specimen with an interference-fit bolt [PDF]
A fatigue analysis, based on finite-element calculations and fatigue tests, was conducted for an aluminum-alloy sheet specimen with a steel interference-fit bolt.
Crews, J. H., Jr.
core +1 more source
Fretting Fatigue with Cylindrical-On-Flat Contact: Crack Nucleation, Crack Path and Fatigue Life. [PDF]
Materials (Basel), 2017 Noraphaiphipaksa N +2 more
europepmc +1 more source
Calculation Method of the Interference Fit Connection Structure Fretting Slip Vector
Jixie chuandong, 2016 When the interference fit connection structure being applied load,its contact surface can produce small relative slip amplitude.When the relative slip amplitude is in a certain range,the fretting fatigue life would be shortened.In order to evaluate the ...
Li Yamei +5 more
doaj
Practical aspects of designing for and evaluating structural integrity [PDF]
The application of procedures for designing and evaluating structural integrity of various construction techniques is discussed. The fatigue performance improvement of the following conditions is described: (1) conical fasteners, (2) hole preparation, (3)
Chaumette, D., Peyrony, M.
core +1 more source