Results 141 to 150 of about 134,575 (292)

Microstructure, Thermal Transport, and Dry‐Sliding Tribology of Powder‐Metallurgy Al7075 Composites Reinforced With Sol–Gel‐Derived ZnO–rGO Hybrid Nanoparticles

open access: yesAdvanced Engineering Materials, EarlyView.
Sol–gel‐derived ZnO–rGO hybrid nanoparticles enable Al7075 powder‐metallurgy composites to achieve concurrent gains in hardness and thermal conductivity while markedly lowering friction and wear. The hybrid architecture couples ZnO‐based load support with rGO‐assisted lamellar sliding and heat spreading, revealing a promising route toward lightweight ...
Bunyamin Aksakal   +3 more
wiley   +1 more source

Strengenthening of concrete bridges using reinforced sprayed concrete under state and fatigue loading.

open access: yes, 1997
PhDThe Department of Transport's bridge assessment programme has revealed that a significant number of bridges are not strong enough to carry the much heavier commercial axle loads that will soon be applied to UK bridges. To address this problem, this
Dung, Pham-Thanh
core  

Advanced Electron Microscopy and Microcomputed Tomography Analysis of Single‐Crystal Ni‐Base Superalloys After Short‐Term Multiaxial Creep

open access: yesAdvanced Engineering Materials, EarlyView.
This work studies the anisotropic behavior of circular notched tensile specimens of Ni‐base superalloy single crystals during high‐temperature tensile creep along [001], [110], and [111]. Correlative scale‐bridging imaging of specimens reveals early rupture along [110] because 1) plastic deformation proceeds faster at notch center; 2) more (brittle ...
Leonardo Agudo Jácome   +6 more
wiley   +1 more source

Texoskeletons: Developing the Fundamental Technologies for Creating Intelligent Soft Robotic Clothing With Integrated 1D Sensors and Actuators

open access: yesAdvanced Functional Materials, EarlyView.
ABSTRACT Traditional wearable exoskeletons rely on rigid structures, which limit comfort, flexibility, and everyday usability. This work introduces the fundamental technologies to create the first soft, lightweight, intelligent textile‐based exoskeletons (Texoskeletons) built using 1D sensors and actuators.
Amy Lukomiak   +19 more
wiley   +1 more source

Electrode and Microstructure Dependence of Oxygen Diffusion in Ferroelectric Hafnium Zirconium Oxide Thin Films

open access: yesAdvanced Functional Materials, EarlyView.
Significant nanoscale oxygen diffusion coefficient variations are measured in ferroelectric hafnium zirconium oxide films with grain boundaries and electrode interfaces exhibiting values 104 times larger than the grain cores. Overall coefficients are 10X larger for films prepared with metal nitride electrodes compared to refractory metals. New insights
Liron Shvilberg   +6 more
wiley   +1 more source

A study of the design and construction of a full scale aircraft component demonstration fatigue test

open access: yes, 1970
The objective of this project was to design and build a full scale demonstration fatigue test for a Piper Aztec stabilator. A general discussion of the construction is included in this report.
Wright, Stephen Andrew
core  

Historical Foundation and Practical Guideline for Ferroelectric Switching Kinetic Studies

open access: yesAdvanced Functional Materials, EarlyView.
The P and U pulses in the conventional PUND measurements are not identical because of the interplay between switching current and the measurement circuit components. This circuit effect can lead to a shift in polarization transients and misinterpreted physics in the switching kinetics.
Yi Liang, Pat Kezer, John T. Heron
wiley   +1 more source

Home - About - Disclaimer - Privacy