Results 31 to 40 of about 1,454,776 (169)

Discussion of Speeding Up Fatigue Test of Full-Scale Aircraft

open access: yesEngineering Proceedings
The full-scale aircraft fatigue test is a critical assessment and validation of the fatigue and damage tolerance design of new aircraft models, and it is also a prerequisite for obtaining the type certification for an aircraft.
Shuang Lv
doaj   +1 more source

The Concept of a Full Scale Fatigue Test of a Su-22 Fighter Bomber

open access: yesFatigue of Aircraft Structures, 2014
This article presents a concept of the full scale fatigue test of a Su-22 fighter bomber. The authors define the general concept and goals of the test as well as the tasks to be accomplished in the preparation stage. The current work status is summarized
Reymer Piotr   +3 more
doaj   +1 more source

Discussions on some problems of full-scale aircraft fatigue test

open access: yesHangkong gongcheng jinzhan
Full-scale aircraft fatigue test is a large, complex and long-lasting ground verification test required by the specification to sustain aircraft structural integrity program and meet airworthiness requirements.
ZHANG Lixin
doaj   +1 more source

The Definition of the Load Spectrum for SU-22 Fighter-Bomber Full Scale Fatigue Test

open access: yesFatigue of Aircraft Structures, 2015
The Su-22 fighter-bomber is a military aircraft used in the Polish Air Force since the mid 1980’s. By the decision of the Polish Ministry of Defense the predicted service life for this type of aircraft will be extended to 3200 flight hours.
Reymer Piotr   +3 more
doaj   +1 more source

Full-Scale Tests of Pipeline Girth Welds Under Complex Cyclic Internal Pressure and Static Bending Loading Conditions

open access: yesInternational Journal of Engineering and Management Sciences, 2023
The critical elements of high-pressure hydrocarbon transporting pipelines are often the girth welds, which are subjected to complex loads. The aims of our research and this paper are to introduce our full-scale pipeline fatigue and burst tests applying ...
Ahmad Yasser Dakhel, János Lukács
doaj   +1 more source

Unsteady RANS CFD Simulations of Sailboat’s Hull and Comparison with Full-Scale Test

open access: yesJournal of Marine Science and Engineering, 2020
The hydrodynamic investigation of a hull’s performance is a key aspect when designing a new prototype, especially when it comes to a competitive/racing environment. This paper purports to perform a fully nonlinear unsteady Reynolds Averaged Navier-Stokes
Pietro Casalone   +5 more
doaj   +1 more source

Experimental Investigation of the Mechanical Behaviour of Wall–Beam–Strut Joints for Prefabricated Underground Construction

open access: yesInternational Journal of Concrete Structures and Materials, 2021
Prefabricated construction is becoming increasingly prevalent, however, it is rarely applied in underground constructions, except for tunnel linings, due to the difficulties that arise in jointing various prefabricated components in underground ...
Tingjin Liu   +3 more
doaj   +1 more source

Loading Tests on Full-Scale House Roofs

open access: yes, 1962
Earlier loading tests on single roof frames had shown that many conven tional rafter-and-joist frames had failure loads well below the design snow loads specified in Canada. This suggested that either actual snow loads were lower than the design values or that the strength of individual roof frames do not indicate full strength of the complete roof ...
Thorburn, H. J., Schriever, W. R.
openaire   +3 more sources

Numerical and Experimental Study on Trimaran Cross-Deck Structure’s Fatigue Characteristics Based on the Spectral Fatigue Method

open access: yesJournal of Marine Science and Engineering, 2019
Spectral fatigue analysis is performed on the trimaran cross-deck structural detail. A global finite element (FE) model with local fine meshes at hot spot locations is built for the calculation of structural response.
Chunbo Zhen   +3 more
doaj   +1 more source

Evaluation on pressure bearing capacity of X70 pipeline with pure dent defect

open access: yesYou-qi chuyun, 2020
In order to evaluate the ultimate pressure bearing capacity of high-grade steel pipeline with pure dent defect, finite element analysis was performed for the deformation of steel pipeline during the formation of dent and the hydraulic test.
Peng SONG   +5 more
doaj   +1 more source

Home - About - Disclaimer - Privacy