Results 161 to 170 of about 21,927 (209)
Some of the next articles are maybe not open access.
A PWM full-bridge converter with natural input power factor correction
PESC 98 Record. 29th Annual IEEE Power Electronics Specialists Conference (Cat. No.98CH36196), 2002A pulsewidth modulated (PWM) full-bridge converter that simultaneously performs input power factor correction (PFC) and DC-DC conversion is proposed. The converter is the same as the standard voltage-fed PWM full-bridge converter with a diode-bridge low-pass filter front end, but with a slight modification that results in an improvement in power factor
G. Moscropoulos +3 more
openaire +1 more source
e & i Elektrotechnik und Informationstechnik, 2019
This paper discusses the challenges for today’s power converter topologies when operating large synchronous motor-generators in pumped storage power plants, which is a medium-voltage high-power application. First, the available ratings and characteristics of the utilized power semiconductor switches are analyzed.
Thomas H. Holzer, Annette Muetze
openaire +1 more source
This paper discusses the challenges for today’s power converter topologies when operating large synchronous motor-generators in pumped storage power plants, which is a medium-voltage high-power application. First, the available ratings and characteristics of the utilized power semiconductor switches are analyzed.
Thomas H. Holzer, Annette Muetze
openaire +1 more source
A Full-Controlled Bidirectional Dual-Stage Interleaved Converter for Interfacing AC and DC Power Grids [PDF]
Power grids are progressing, and the possibility of incorporating DC grids toward hybrid AC/DC grids is gaining increasing relevance, as several technologies available nowadays are operating natively in DC.
Vitor Monteiro +2 more
exaly +3 more sources
Research on Full Bridge Converter of Magnetron Sputtering Power Supply
2019 14th IEEE Conference on Industrial Electronics and Applications (ICIEA), 2019Phase-shifted full bridge(PSFB) topology was used in the main circuit of high-power magnetron sputtering power supply (MSPS), which greatly improves power efficiency by means of soft-switching. The traditional topology has the problems of difficult to realize soft-switching of lag arm, the loss of duty cycle and the large circulation loss.
Xiping Huang +3 more
openaire +1 more source
Single stage full bridge converter with power factor correction
2001 IEEE 32nd Annual Power Electronics Specialists Conference (IEEE Cat. No.01CH37230), 2002The full-bridge converter with isolation transformer is the preferred topology for medium and high power SMPS. A simple topology modification, i.e. the addition of two input inductors, and appropriate control methods permit simultaneous and accurate control of the output voltage and the input current, performing a new single stage SMPS.
A. Victor, A. Anunciada, R.D. Monteiro
openaire +1 more source
Analysis of full bridge DC-DC converter in power system
2011 4th International Conference on Electric Utility Deregulation and Restructuring and Power Technologies (DRPT), 2011Isolated dc-dc converter is widely used in power system, especially in green power applications. Compared with the other circuits, full bridge converter is more suitable for power system, where high power and high voltage are involved. This paper proposes the full bridge converter with the uncontrolled rectifier.
Ren Beibei +4 more
openaire +1 more source
Improvements in the grid connection of renewable generators with full power converters
Renewable Energy, 2012Abstract The increasing penetration of electricity generation from renewable energy is posing new technical challenges to the operation of power systems. Some of them are related to the different electrical behavior of the generators when compared with traditional directly coupled synchronous generators.
Dionisio Ramirez +3 more
openaire +1 more source
Boost full bridge DC-DC converter based modular converter for Telecom Power Supplies
2012 IEEE Fifth Power India Conference, 2012In this paper, a medium power TPS (Telecommunication Power Supply) is designed in DCM (Discontinuous Conduction Mode) using a series combination of IPQCs (Improved Power Quality Converters) namely boost full bridge DC-DC converters with the diode bridge rectifiers at the front end.
Bhim Singh +2 more
openaire +1 more source
LVRT Control Strategy of Full Power Converter with LCL Filter
2012In order to enhance the low voltage ride through (LVRT) capability of full power converter, an improved control strategy was proposed. LCL filter was used to reduce the harmonics. An active damping method was introduced for the passive damping producing great quantity losses. A lead-lag element was added to enhance the damping.
Jian Liu, Guijie Yang
openaire +1 more source
Power control analysis for variable speed pumped storage with full-size converter
IECON 2015 - 41st Annual Conference of the IEEE Industrial Electronics Society, 2015Variable speed pumped storage (VSPS) with full-size converter can be an effective measure for automatic frequency control and balancing renewable generation power fluctuation. This paper mainly studies the modeling and control strategies of both the machine-side and grid-side converter, basing on the structure of VSPS with three-level full-size ...
Xin Chang, Minxiao Han, Chao Zheng
openaire +1 more source

