Results 11 to 20 of about 126,003 (290)
Mi-24 Helicopter Full Scale Fatigue Test Concept
This paper presents a general concept of the Full Scale Fatigue Test of the Mi-24 helicopter including the test layout and load distribution, as well as describes the milestones to be achieved.
Reymer Piotr +9 more
doaj +3 more sources
Discussions on some problems of full-scale aircraft fatigue test
Full-scale aircraft fatigue test is a large, complex and long-lasting ground verification test required by the specification to sustain aircraft structural integrity program and meet airworthiness requirements.
ZHANG Lixin
doaj +2 more sources
Test System Development and Experimental Study on the Fatigue of a Full-Scale Steel Catenary Riser
This paper presents a full-scale deep-water steel catenary riser fatigue test system. The proposed system can carry out fatigue tests on steel catenary risers, hoses, and subsea pipelines up to 21 m in length, ranging from 8 to 24 inches in diameter. The
Jianxing Yu +5 more
doaj +2 more sources
The Concept of a Full Scale Fatigue Test of a Su-22 Fighter Bomber
This article presents a concept of the full scale fatigue test of a Su-22 fighter bomber. The authors define the general concept and goals of the test as well as the tasks to be accomplished in the preparation stage. The current work status is summarized
Reymer Piotr +3 more
doaj +2 more sources
FATIGUE FRACTURE ANALYSIS OF EXCAVATOR BOOM BASED ON FULL-SCALE ACCELERATED LOADING TEST (MT)
To analyze the fatigue fracture causes of boom during normally working service, the boom bench fatigue test scheme was proposed. The measured joints multi-load was equivalent to a uniaxial load based on the fatigue damage consistent principle.
XIANG QingYi, Lü PengMin, WANG PengHui
doaj +2 more sources
Monitoring of a Full-Scale Wing Fatigue Test [PDF]
A wing of a decommissioned aircraft of the Royal Netherlands Air Force (RNLAF) was fatigue tested to more than two times the design life. Part of the test was the evaluation of load monitoring and Structural Health Monitoring (SHM) techniques. For load monitoring the data of conventional resistance strain gauges was compared with the response of ...
Heida, Jaap, Hwang, Joong Sun
core +4 more sources
Fatigue properties of tension leg tendon: A full-scale approach
The tension leg platform is a typical compliant platform that is connected to the seabed through tension leg tendons. However, it is hard to characterize tension leg tendons due to the complexity of their force and motions as well as the lack of full ...
Jing Zhao +5 more
doaj +2 more sources
An acoustic holography and its practical applications in engineering began to develop at the end of the 20th century. Currently, this technique is being commonly used to locate sound sources.
Leski Andrzej
doaj +2 more sources
Small and Full-Scale Fatigue Testing of Lead Cable Sheathing [PDF]
The fatigue behavior of a PbSnSb alloy used in subsea power cable sheathing was studied using small- and full-scale experiments. The aim of the work was to understand the transferability between the scales and suitable testing methods. Creep phenomena are addressed by considering the cyclic strain rate as well as the small-scale loading mode.
Johanson, Audun +3 more
core +3 more sources
Improved resonance method for fatigue test of full-scale wind turbine blades
To further reduce the power of exciter in the common fatigue testing methods and increase the testing frequency to decrease the fatigue testing time, this paper proposes an improved fatigue testing method—Tug Fatigue Testing system (TFTs). The advantages
Aiguo Zhou +3 more
doaj +1 more source

