Results 141 to 150 of about 26,272 (316)
Live Imaging of Silver Nanostructures Electrochemically Dissolving at Open‐Circuit Potential
Small, EarlyView.Stability of electrocatalysts as used in energy conversion systems is pivotal for sustainable technologies, yet degradation dynamics at the nanoscale remain elusive. Harnessing beam‐effect corrected electrochemical liquid phase electron microscopy combined with correlative bulk‐scale electrochemical testing reveals silver corrosion on platinum under ...
Andreas Körner +11 more
wiley +1 more source
Evaluation of thermal sprayed metallic coatings for use on the structures at Launch Complex 39 [PDF]
The current status of the evaluation program is presented. The objective was to evaluate the applicability of Thermal Sprayed Coatings (TSC) to protect the structures in the high temperature acid environment produced by exhaust of the Solid Rocket ...
Welch, Peter J.
core +1 more source
Silver-base ternary alloy proves superior for slip ring lead wires [PDF]
, 1966 Slip ring lead wires composed of ternary alloys of silver, have high electrical conductivity, a tensile strength of at least 30,000 psi, high ductility, and are solderable and weldable.
Ernst, R. H., Williams, D. N.
core +1 more source
Small Methods, EarlyView.An ether‐based high‐entropy electrolyte is prepared by mixing multiple ether solvents, an F‐rich ether, and co‐solvent H2O. The diversity of solvent species enhances the solvation entropy and accelerates reaction kinetics. Additionally, the electrolysis and hydrolysis of solvents and salts yield a uniform ZnF2 interfacial layer to protect the electrode
Ziqing Wang +4 more
wiley +1 more source
A Finite Element Model of Transient Galvanic Corrosion Behaviour of Aluminium Alloy
Electrochemical Science AdvancesThe environment in which aircraft are used is very complex, and factors such as high salinity, high humidity atmospheric conditions and mechanical loads applied to the aircraft during flight can lead to damage to the fuselage materials and compromise the
Jieshun Tang +5 more
doaj +1 more source
Massive osteolysis due to galvanic corrosion after total knee arthroplasty: a rare cause for early revision? [PDF]
J Surg Case Rep, 2020 Zee MJM, van Bemmel BC, van Raay JJAM.
europepmc +1 more source
steel research international, EarlyView.Cold spray deposition of stainless steel (grade: SS304) is evaluated for marine applications, with emphasis on martensitic transformation during impact. Analytical modeling, simulations, and experiments reveal that helium‐assisted spraying of fine powders promotes cooling below the martensitic start temperature, enabling up to ≈40% austenite to ...
Cal Vin Wong +4 more
wiley +1 more source
Friction and wear of iron in sulfuric acid [PDF]
Elemental iron sliding on aluminum oxide in aerated sulfuric acid concentrations ranging from very dilute (0.000007 N; i.e., 4 ppm) to very concentrated (96 percent acid) was studied. Load and reciprocating sliding speeds were kept constant.
Buckley, D. H. +2 more
core +1 more source
Scaling Properties of Galvanic Current Measured by Atmospheric Corrosion Monitors.
, 2001 Wataru Oshikawa, Masatoshi Saitou
openalex +2 more sources
steel research international, EarlyView.Heat treatments that alter the proportions of austenite and ferrite phases or induce the precipitation of phases such as sigma in duplex stainless steel UNS S32205 make it more susceptible to pitting and crevice corrosion. However, the effects of these treatments are not always evident when analyzed using the cyclic polarization technique.
Alba Regina Turin +8 more
wiley +1 more source