Results 181 to 190 of about 1,240,550 (316)

Karl Popper and the Mechanisms of Hydrogen Embrittlement

Advanced Engineering Materials, EarlyView.
Representation of the beginning of loss of ductility rather than embrittlement. Small concentrations of hydrogen in a diffusible form within iron are well‐established to harm the mechanical integrity of steels. There are theories that attempt to explain the pernicious role of hydrogen.
H. K. D. H. Bhadeshia
wiley   +1 more source

Ictal gamma increase shows preferential localization to seizure onset contacts in stereoelectroencephalography. [PDF]

Front Neurol
Jian Y, Hou K, Zhang W, Wang L, Wang J.
europepmc   +1 more source

Multimodal Data‐Driven Microstructure Characterization

Advanced Engineering Materials, EarlyView.
A self‐consistent autonomous workflow for EBSP‐based microstructure segmentation by integrating PCA, GMM clustering, and cNMF with information‐theoretic parameter selection, requiring no user input. An optimal ROI size related to characteristic grain size is identified.
Qi Zhang, Santiago Benito, Özge Özgün, Sebastian Weber, Markus Stricker   +4 more
wiley   +1 more source

Slip Localization Intensification Mediated by Grain Boundary Sliding in a Polycrystalline Nickel‐Based Superalloy

Advanced Engineering Materials, EarlyView.
The temperature dependence of fatigue behavior in nickel‐based superalloys is investigated through high‐resolution measurements of plastic localization. While increasing temperature reduces localization and enhances fatigue performance in René 88DT, Inconel 718 exhibits a sharp degradation at intermediate temperature due to intensified slip ...
M. Calvat, D. Anjaria, I. Woo, C. Bean, D. Texier, J. C. Stinville   +5 more
wiley   +1 more source

A goat-derived gamma-tubulin antibody for triple-channel imaging of primary cilia. [PDF]

BMC Mol Cell Biol
Karapetian E, Gerhardt C, Lemanska N, Budnik M, Stahl E, Füner J, Hirschberg S, Pfirrmann T.   +7 more
europepmc   +1 more source

Creep‐Induced Microstructural Evolution in an A2‐B2 Superalloy

Advanced Engineering Materials, EarlyView.
A 27.3Ta‐27.3Mo‐27.3Ti‐8Cr‐10Al (at.%) refractory high‐entropy alloy with precipitation‐strengthened A2‐B2 microstructure was studied by creep tests at 1030°C, which demonstrate a transition in deformation mechanisms in the range of 100–150 MPa applied stress. This is associated with changes in dislocation–precipitate interactions. Relevant deformation
Liu Yang, Aparajita Pramanik, Sandipan Sen, Shubhashis Dixit, Marcel Muench, R. J. Vikram, Daniel Schliephake, Yolita M. Eggeler, Ankur Chauhan, Martin Heilmaier, Alexander Kauffmann   +10 more
wiley   +1 more source

Daftar Isi GAMMA Volume 4 Nomor 2, Maret 2009

, 2012
Volume 4 Nomor 2, Maret 2009ISSN : 0216 - 9037Ariasi Perendaman Pada Campuran Beton Aspal Terhadap Nilai Stabilitas MarshallAndi Saiful Amal 81 - 85Model Simulasi Untuk Penyelesaian Problem Integrasi Produksi-DistribusiAnnisa Kesy Gaside 86 - 94Disain ...
Isi, Daftar
core  

Gamma Knife Radiosurgery for Arteriovenous Malformations Presenting as Secondary Trigeminal Neuralgia: A Case Series.

Brain and Spine, 2023
Ali Haluk Duzkalir, Yavuz Samanci, Mehmet Orbay Askeroglu, Selcuk Peker   +3 more
doaj   +1 more source

A construction of statistical inferences in geographically weighted univariate log-gamma regression. [PDF]

MethodsX
Rini DS, Purhadi, Andari S.
europepmc   +1 more source

Creep Properties and Deformation Mechanism of Additively Manufactured NiAl‐CrMo Composites

Advanced Engineering Materials, EarlyView.
Additively manufactured NiAl‐CrMo composites contain numerous interfaces and cell boundaries that control their creep response. At 700°C under high applied stress, creep is dominated by dislocation‐controlled power‐law mechanisms. At 800°C–900°C and lower stresses, creep is primarily diffusion‐controlled along cell boundaries.
Jan Vollhüter, Andreas Bezold, Johan Westraadt, Katharina Fiegl, Subham Chattoraj, Benjamin Wahlmann, Carolin Körner, Michael Mills, Mathias Göken, Steffen Neumeier   +9 more
wiley   +1 more source