Results 111 to 120 of about 660,505 (314)
Monitoring of gas emissions at landfill sites using autonomous gas sensors [PDF]
, 2010 Executive Summary This report details the work carried out during the Smart Plant project (2005-AIC-MS-43-M4). As part of this research, an autonomous platform for monitoring greenhouse gases (methane (CH4), carbon dioxide (CO2)) has been developed,
Beirne, Stephen +3 more
core
Assessing Altered Coating Adhesion on Plasma‐Deoxidized Surfaces Under Oxygen‐Free Conditions
Advanced Engineering Materials, EarlyView.This study demonstrates the effectiveness of atmospheric pressure plasma pretreatment in modifying silicon and stainless steel surfaces to improve adhesion. Argon‐hydrogen plasma increases surface roughness and improves adhesion strength, whereas pure argon results in smoother surfaces and structural changes.
Selina Raumel +6 more
wiley +1 more source
Advanced Engineering Materials, EarlyView.This work explores the reduction of nickel oxide layers using dielectric barrier discharge plasma in an argon–hydrogen atmosphere. The results reveal a strong temperature dependence, enabling complete reduction of thick oxide layers at 200°C within seconds.
Maria Argirusi +5 more
wiley +1 more source
Low‐Angle Grain Boundaries and Re‐Segregation in Single‐Crystalline Ni‐Base Superalloys
Advanced Engineering Materials, EarlyView.This work demonstrates that Re‐segregation at low‐angle grain boundaries (LAGBs) in Ni‐base superalloys is influenced by misorientation angle. Advanced microscopy and atom probe tomography reveal that higher misorientation angles increases Re‐segregation.
Alireza B. Parsa +9 more
wiley +1 more source
Advanced Engineering Materials, EarlyView.This study demonstrates how optimizing laser power, scanning speed, and hatching distance in laser powder bed fusion can boost the productivity of Inconel 718 manufacturing by up to 29% while maintaining mechanical integrity. The work delivers a validated process window and cost–time analysis, offering industry‐ready guidelines for efficient additive ...
Amir Behjat +7 more
wiley +1 more source
Advanced Engineering Materials, EarlyView.The subject of this work is the development of a corrosion‐protective coating on steel sheets for form hardening. Rapid heating in an extreme high vacuum (XHV)‐adequate atmosphere is a useful method to prevent oxidation during alloying of 22MnB5 and aluminum to obtain a metallurgical bonding.
Lorenz Albracht +5 more
wiley +1 more source
Applied SciencesBased on the engineering problem of large deformation and support failure in the roadway of Ronghua No. 1 Mine, on-site in situ stress testing was carried out to understand the distribution characteristics of the in situ stress around the roadway.
Shulin Liu +6 more
doaj +1 more source
Advanced Engineering Materials, EarlyView.New features on yttria‐stabilized zirconia after exposure at 1500°C: Newly discovered pyramidal structures on an old material. After exposure at 1550°C on the cross section of YSZ new features, namely pyramidal structures are discovered. These structures grow with time, increase in numbers, appear as singularities, are often arranged in strings, and ...
Doris Sebold +2 more
wiley +1 more source
Influence Mechanism of Gas Pressure on Multiscale Dynamic Apparent Diffusion-Permeability of Coalbed Methane. [PDF]
ACS Omega, 2023 Li Z +6 more
europepmc +1 more source
The study of the effect of water vapour in methane and helium on humidity sensing
, 2009 This thesis was submitted for the degree of Master of Philosophy and awarded by Brunel University.The calibration of humidity sensors is usually carried out in air and at near ambient pressure.
Pothinual, Wepawadee
core