Results 61 to 70 of about 660,505 (314)
ABSTRACT As global populations age, cancer is increasingly becoming a leading cause of morbidity and mortality among older adults, particularly in low‐ and middle‐income countries (LMICs). Despite accounting for the majority of new cancer cases and deaths, older individuals remain underrepresented in cancer research, clinical guidelines, and health ...
Ibrahim Bidemi Abdullateef +2 more
wiley +1 more source
Gas and solid behaviours during defluidisation of Geldart-A particles [PDF]
Bed collapsing experiments were carried out in a cold-air transparent column 192 mm in diameter and 2 m high. Typical Fluid Catalytic Cracking (FCC) catalyst with a mean particle size of 76 μm and a density of 1400 kg/m3 was used.
E.T. Santos +7 more
core +1 more source
The stability criteria affecting the formation of high‐entropy alloys, particularly focusing in supersaturated solid solutions produced by mechanical alloying, are analyzed. Criteria based on Hume–Rothery rules are distinguished from those derived from thermodynamic relations. The formers are generally applicable to mechanically alloyed samples.
Javier S. Blázquez +5 more
wiley +1 more source
PRESSURE PREDICTION AND UNDERBALANCED DRILLING IN THE DEEPWATER NIGER DELTA [PDF]
The mechanisms that cause overpressure can be broadly classified into two categories: loading and unloading. This study looks at eight wells from the deepwater Niger Delta; the wells were evaluated with three aims in mind. The first aim was to determine
GOODWYNE, OLAR,KAMAL
core
MRI of fluids containing lipid coated microbubbles has been shown to be an effective tool for measuring the local fluid pressure. However, the intrinsically buoyant nature of these microbubbles precludes lengthy measurements due to their vertical ...
Galvosas, Petrik +15 more
core +1 more source
Fluidization of Group B particles with a rotating distributor [PDF]
A novel rotating distributor fluidized bed is presented. The distributor is a rotating perforated plate, with 1% open-area ratio. This work evaluates the performance of this new design, considering pressure drop, Δp, and quality of fluidization.
Sobrino Fernández, Celia +6 more
core +1 more source
The tribological behavior of 100Cr6 steel spheres textured via Vickers microindentation is evaluated under lubricated sliding by varying both dimple size and density. Fine and dense textures significantly reduce friction across all lubrication regimes, while large dimples increase it.
Farideh Davoodi +3 more
wiley +1 more source
Ethanol-blended gasolines show enhanced anti-knock behavior in spark-ignition engines. Fundamental experimental investigations on their auto-ignition behavior are however scarce in the literature.
Jiaqi Zhang +7 more
doaj +1 more source
Source mechanism regimes for the acoustic signals generated during the expansion of rising and bursting gas slugs in low-viscosity magmas. [PDF]
V53C-2281 Strombolian eruptive activity produces gas-rich, magma-poor ejecta suggesting the separation and concentration of volcanic gases within the plumbing system. These gases may then rise as relatively large bubble rafts or individual 'slug' bubbles,
Lane, Stephen +2 more
core
This study presents a reversible temperature sensor with high switching ratio, ∼103. The device is fabricated using PET‐ITO and carbon nanotube dispersions in alkane. Considering its application in cold chain logistics, a proof‐of‐concept with LED is showcased. Thus, a temperature drop below the threshold temperature (crystallization temperature of the
Sunil Kumar Behera +8 more
wiley +1 more source

