Results 211 to 220 of about 62,083 (259)
Some of the next articles are maybe not open access.
Swelling and Gas Release in ZnO
Journal of the American Ceramic Society, 1980Swelling and gas release in a model ceramic system, ZnO, were studied under known internal and external pressures, oxygen partial pressures, and temperatures. When gas was not released, the instantaneous swelling strain rate was: εα( DF exp‐Q/RT) where DF
A. A. SOLOMON, F. HSU
openaire +1 more source
Measurement of Swelling for PP/Gas Mixtures
SAE Technical Paper Series, 2005<div class="htmlview paragraph">Foaming of thermoplastic polyolefins (TPO) and thermoplastic elastomers (TPE) is gaining interest because of the lightweight and high performance to weight ratio of foamed automotive parts. Since foaming will occur mainly in the PP matrix in these PP-based automotive materials, understanding of the thermophysical ...
Y. G. Li, J. Wang, C. B. Park
openaire +1 more source
Kinetics of Gas-Bubble Swelling in Silver
Journal of Applied Physics, 1971A nondestructive method has been used to monitor continuously the volume changes in thin-walled tubes of oxygen-bearing silver which were heated in an argon ambient containing a few percent hydrogen. A large direct current was used to heat the samples while their ends were water cooled.
H. R. Patil, H. B. Huntington
openaire +1 more source
Evaluation of gas sorption-induced internal swelling in coal
Fuel, 2015Abstract Gas sorption plays an important role in permeability evolution and gas flow in coal. Many efforts have been made to evaluate the effect of gas sorption on permeability. For example, the total gas sorption matrix swelling is divided in to two pars, one acts on cleat (internal swelling) and the other contributes to coal block deformation ...
Jie Zang, Yixin Zhao
exaly +2 more sources
Reversibility of fission gas swelling in uranium
Journal of Nuclear Materials, 1969Abstract The effect of hydrostatic pressures up to 1000 bar on the behavior of pre-formed bubbles in irradiated uranium has been studied. High pressure, 900 °C anneals cause the fission gas swelling, induced in uranium by 600 °C vacuum anneals, to be reversed. Subsequent high temperature (900–1080 °C) vacuum tests produce the same swelling as samples
G.L. Kulcinski, R.D. Leggett
openaire +1 more source
The theory of degassing and swelling of a supersaturated-by-gas solution
Physica A: Statistical Mechanics and its Applications, 2017zbMATH Open Web Interface contents unavailable due to conflicting licenses.
Kuchma, A. E. +2 more
openaire +1 more source
Mechanisms of swelling and gas release in uranium dioxide
Journal of Nuclear Materials, 1971Abstract Data on the external dimensional changes and gas release behavior of uranium dioxide irradiated in tungsten-rhenium claddings at surface temperatures from 1325 to 1900 °C are presented. External dimensional changes and gas release fractions increase with increasing temperatures; but the density of the uranium dioxide shows little change ...
R.F. Hilbert +3 more
openaire +1 more source
Fission gas swelling of refractory nuclear fuels
Materials Science and Engineering, 1972Abstract The external diametral swelling rates of uranium oxides, nitrides and carbides at temperatures of up to 1900°C are presented. Under similar conditions, the swelling rates are seen to increase from approximately 0.2 percent per 1020 fissions per cm3 at 1200°C to 10–30 percent per 1020 fissions per cm3 at 1900°C.
W Chubb +3 more
openaire +1 more source
Contribution of polymeric swelling to the overall response of capacitive gas sensors
Analytical and Bioanalytical Chemistry, 2013A new method for investigation of the swelling of polymers on exposure to gas or vapour has been devised and tested. It uses an optical profilometer (based on the chromatic aberration of a lens system) which is integrated into a computer-controlled gas-dosing and mixing setup. Gas and/or vapour concentration-dependent measurements have been carried out
Altenberend, Ulrike +3 more
openaire +3 more sources
Swelling and gas release in UO2 at low and intermediate temperatures
Journal of Nuclear Materials, 1977Abstract A model is proposed to describe in-pile fission gas swelling and gas release at temperatures below approximately 1700°C where columnar grain growth is not expected. The model considers fission gas behavior at the grain interior, on the grain boundaries and grain boundary edges under conditions of both total gas bubble destruction by fission ...
C.C. Dollins, F.A. Nichols
openaire +2 more sources