The combustion of lemon peel oil/gasoline blends in spark ignition engine with high-insulation piston crown coating. [PDF]
Saravanan CG +6 more
europepmc +1 more source
Research on the Accelerated Fatigue Experiment Method of the Crankshaft Based on a Modified Particle Filtering Algorithm and the Fatigue Crack Growth Property. [PDF]
Fu J +5 more
europepmc +1 more source
A multi-criteria sustainability and engine performance study of andropogon narudus biodiesel using the PUGH matrix and ML. [PDF]
Pv E +7 more
europepmc +1 more source
Multi-Parametric Evaluation of a Novel Benzoylthiourea Derivative as a Combustion Modifier in Diesel-Ethanol Blends Under EGR Conditions. [PDF]
Coşman S.
europepmc +1 more source
Editorial for Special Issue "Research on Friction, Wear and Corrosion Properties of Materials". [PDF]
Liu Y, Ma Y.
europepmc +1 more source
Influence of road and traffic conditions on emissions and fuel consumption of light vehicles in a real urban driving cycle. [PDF]
Nitoiu C, Cofaru C, Popescu M.
europepmc +1 more source
Related searches:
<div class="htmlview paragraph">The present spark ignition, reciprocating piston, gasoline engine is examined against the basic requirements for an automotive powerplant. The important requirement of emission control is shown to affect these basic requirements. The emission potential of this engine and the prospect of reducing its emissions to an
Albert G. Lucas, George W. Niepoth
openaire +1 more source
The future of gasoline engines
2015Both the future test cycles and more fuel-efficient transmission and electrification concepts are shifting the ICE operation towards higher engine loads. Whereas in the past, FE measures with Gasoline Engines were mainly concentrated on the reduction of throttle losses, in future the extension of the sweet spot area becomes decisive.
Günter Fraidl, P. Kapus
openaire +1 more source
Combustion in Gasoline Engines
1990The rate of burning in the cylinder exercises considerable influence upon the power and efficiency of the engine. Combustion should occur close to top centre and be rapid enough to utilize to the fullest possible extent the maximum compression, and yet not be so rapid as to induce strong shock waves in the gas or intolerable impact loadings on bearings
openaire +1 more source

