Results 31 to 40 of about 852,934 (411)
Estimates of fishing gear loss rates at a global scale: A literature review and meta‐analysis
Fish and Fisheries, 2019 Abandoned, lost or otherwise discarded fishing gear (ALDFG) represents a significant, yet ultimately unknown amount of global marine debris, with serious environmental and socioeconomic impacts.
K. Richardson, B. D. Hardesty, C. Wilcox
semanticscholar +1 more source
IEEE Access, 2020 The decomposition number $K$ and penalty factor $\alpha $ in the variational mode decomposition (VMD) algorithm have a great influence on the decomposition effect and the accuracy of subsequent fault diagnosis.
Jiakai Ding, Dongming Xiao, Xuejun Li
semanticscholar +1 more source
Effects of Different Hard Finishing Processes on Gear Excitation
Machines, 2021 Gearboxes are essential in mechanical drive trains for power transmission. A low noise emission and thus an optimized excitation behavior is a substantial design objective for many applications in terms of comfort and operational safety.
Maximilian Trübswetter +4 more
doaj +1 more source
Potential of oil-lubricated cylindrical plastic gears
Journal of Advanced Mechanical Design, Systems, and Manufacturing, 2018 Bending strength of injection molded polyacetal test gears is investigated in back-to-back testing using oil-lubrication. To validate state of the art calculation methods, tooth geometries with a variable number of teeth are investigated, maintaining a ...
Christian HASL +4 more
doaj +1 more source
The Gap-Tooth Method in Particle Simulations
, 2003 We explore the gap-tooth method for multiscale modeling of systems represented by microscopic physics-based simulators, when coarse-grained evolution equations are not available in closed form.
C.William Gear +19 more
core +1 more source
Novel spectral kurtosis technology for adaptive vibration condition monitoring of multi-stage gearboxes [PDF]
, 2016 In this paper, the novel wavelet spectral kurtosis (WSK) technique is applied for the early diagnosis of gear tooth faults. Two variants of the wavelet spectral kurtosis technique, called variable resolution WSK and constant resolution WSK, are ...
Barbieri, M. +5 more
core +1 more source
Nihon Kikai Gakkai ronbunshu, 2022 We have developed a small size and high strength spiral bevel gear fabricated by five-axis controlled machining center. In the present report, we propose a novel spiral bevel gear with the rib at the end of face width to reinforce the tooth bending ...
Masahiro SAITO +3 more
doaj +1 more source
Applied Sciences, 2021 In this paper, the authors present the design of a suitable gear transmission with the continuously changing gear ratio in the range from 0.5 through 1.0 to 2.0 and back during one revolution of intermeshing gears, according to demands specified for a ...
Silvia Maláková +4 more
semanticscholar +1 more source
Journal of Advanced Mechanical Design, Systems, and Manufacturing, 2017 The grinding of case-hardened gears after the heat treatment ensures a high quality regarding the gear geometry and tooth surface topography. If the limits of the gear material are exceeded during this process, the mechanical and thermal influence from ...
Johannes KOENIG +3 more
doaj +1 more source
Lubricants, 2019 Friction behavior in a sliding contact is strongly influenced by the surface topography of the bodies in contact. This also applies to friction clutches. Even small differences in surface topography may cause significant differences in friction behavior.
Katharina Voelkel +5 more
doaj +1 more source