Results 11 to 20 of about 179,529 (193)
Review of methods of designing and additive manufacturing of gears [PDF]
Biuletyn Wojskowej Akademii Technicznej, 2021 Additive manufacturing (AM) technology is one of the main components of the fourth industrial revolution known as Industry 4.0. Over the last decades, increase in the dynamics of the development of this technology manifests itself in the form of a wide ...
Jakub Łuszczek
doaj +1 more source
Applied Sciences, 2020 The lubrication of the mechanical components reduces friction, and increases the efficiency and the reliability. However, the interaction of moving components with the lubricant leads to power losses due to viscous and inertial effects.
Lorenzo Maccioni, Franco Concli
doaj +1 more source
Influence of hardening on the microstructure and the wear capacity of gears made of Fe1.5Cr0.2Mo sintered steel [PDF]
Science of Sintering, 2010 High demands are set on gears made from sintered steel regarding wear, fretting, tooth fracture and pitting load capacity. The hardening obtained after the sinter process will affect the microstructure of the sintered steel so that the wear load ...
Predki W., Miltenović A.
doaj +1 more source
Metals, 2021 Mechanical components, such as gears, are usually subjected to variable loads that induce multiaxial non-proportional stress states, which in turn can lead to failure due to fatigue.
Franco Concli +3 more
doaj +1 more source
Surface Life Modelling of Tribological Components – From Surface Roughness to Bearings and Gear Life
Tribology Online, 2023 With stringent environmental regulations and tougher economic reasons, tribological components like rolling bearings and gears are constantly under scrutiny when it comes to energy efficiency and reliability.
Guillermo Enrique Morales-Espejel
doaj +1 more source
Applied Sciences, 2023 Due to their cost-effectiveness, pulsator tests are widely adopted as a testing methodology for the investigation of the effects of material and heat and surface treatment on the gear strength with respect to tooth root fatigue fracture.
Luca Bonaiti +4 more
doaj +1 more source
Numerical simulation of three-phase flow in an external gear pump using immersed boundary approach [PDF]
, 2019 This paper presents a three-phase fully compressible model applied along with an immersed boundary model for predicting cavitation occurring in a two dimensional gear pump in the presence of non-condensable gas (NCG).
Gavaises, M. +3 more
core +1 more source
Antitrust, the Gig Economy, and Labor Market Power [PDF]
, 2014 The purpose of the current study was to develop and validate an automatic algorithm for classification of cross-country (XC) ski-skating gears (G) using Smartphone accelerometer data.
Anders Holst +6 more
core +3 more sources
Drop-On-Demand Lubrication of Gears: A Feasibility Study
Frontiers in Mechanical Engineering, 2021 Different lubrication methods such as oil dip or injection lubrication are used in gearboxes to lubricate tribological contacts and to dissipate frictional heat.
M. Mirza +4 more
doaj +1 more source
Experimental rigs for testing components of advanced industrial applications
Friction, 2018 This paper presents experimental rigs of the Research Centre for the Mechanics of Turbomachinery of the Department of Civil and Industrial Engineering of the University of Pisa.
Enrico Ciulli
doaj +1 more source