Results 21 to 30 of about 6,036 (184)
Influence of Filler Surface Modification on Static and Dynamic Mechanical Responses of Rice Husk Reinforced Linear Low-Density Polyethylene Composites [PDF]
Filler surface modification has become an essential approach to improve the compatibility problem between natural fillers and polymer matrices. However, there is limited work that concerns on this particular effect under dynamic loading conditions ...
Mohd Firdaus Omar +8 more
doaj +1 more source
An Investigation of TiO2 Addition on Microstructure Evolution of Sn-Cu-Ni Solder Paste Composite
In this research, varying fraction of titanium oxide (TiO2) reinforcement particles was successfully incorporated into Sn-Cu-Ni solder paste in an effort to study the influence of TiO2 addition on microstructure evolution of Sn-Cu-Ni solder paste ...
Saud Norainiza +5 more
doaj +1 more source
The influence of Activated Carbon (AC) particles on mechanical properties of Sn-Cu-Ni-xAC solder joint was investigated. Five different Activated Carbon (AC) percentage addition (0 wt. %, 0.25 wt. %, 0.5 wt. %, 0.75 wt. %, and 1.0 wt.
Ramli M.I.I. +4 more
doaj +1 more source
Effect of Adding Polypropylene Fibers in Met kaolin-Based Geopolymer Concrete [PDF]
Geopolymer is a binder material that was created as a result of efforts to decrease Portland cement's negative environmental effects. Geopolymer concrete shares certain properties with ordinary concrete, including brittleness.
Qais Frieh, Mushtaq Kamil
doaj +1 more source
Monitoring Methods on Evolution of Alkali Activation of Alkali-Activated Materials [PDF]
Alkali activation for producing alkali-activated materials is noted as a complex due to involving several reactions. Due to complexity of the reactions, various techniques have been applied by past researches on monitoring the evolution of alkali ...
R. Mohamed +7 more
doaj +1 more source
Studying the behavior of geopolymer concretes under repeated loadings
This article investigates utilization of polypropylene microfibers as reinforcement in geopolymer concrete to enhance the ductility characteristics since the geopolymer concrete is considered a brittle material.
Osamah M. G. Al-Kerttani, Ammar Mutar
doaj +1 more source
Review of Dolomite as Precursor of Geopolymer Materials
Geopolymer is an environmentally friendly cementitious binder that does not require the existence of ordinary Portland cement (OPC). Geopolymer has many excellent advantages, including high early strength, low shrinkage, good thermal resistance and good ...
Azimi E.A. +5 more
doaj +1 more source
Palm Ash as an Alternative Source for Silica Production
Agricultural wastes such as palm ash and rice husk have a possibility to be used as a useful renewable source for the production of silica (SiO2). Extensive researches have been carried out to extract silica from agricultural wastes such as rice husk ...
Pa Faizul Che +2 more
doaj +1 more source
BEARING LOAD CAPACITY of GEOPOLYMER CONCRETE THIN WALL PANELS UNDER ECCENTRIC COMPRESSION [PDF]
Due to the current diffusion of reinforced concrete (RC) walls structures and the introduction of new concrete cords, RC walls are an important structural element such as beams, plates and columns. The experimental program included casting and testing of
Sahar Jabbar Alserai +2 more
doaj +3 more sources
In this study, the influence of Trans- Polyoctylene Rubber (TOR) as a compatibilizer on the cure characteristics, tensile and physical properties of ENR-25/rSC vulcanizate were determined.
Dahham Omar S. +6 more
doaj +1 more source

