Results 21 to 30 of about 190,007 (315)
Surface plasmon resonance assisted rapid laser joining of glass [PDF]
, 2014 Rapid and strong joining of clear glass to glass containing randomly distributed embedded spherical silver nanoparticles upon nanosecond pulsed laser irradiation (40 ns and repetition rate of 100 kHz) at 532 nm is demonstrated.
Abdolvand, A. +13 more
core +1 more source
Prospects of Photonic Crystal Fiber as Physical Sensor: An Overview
Sensors, 2019 Photonic crystal fiber sensors have potential application in environmental monitoring, industry, biomedicine, food preservation, and many more. These sensors work based on advanced and flexible phototonic crystal fiber (PCF) structures, controlled light ...
Moutusi De +2 more
doaj +1 more source
Analysis of glass fiber reinforced cement (GRC) fracture surfaces
, 2010 Glass fiber reinforced cement (GRC) is a composite material produced by the union of a cement mortar matrix and chopped glass fibers. Its good mechanical properties deteriorate with time. This phenomenon has been studied performing a tensile test program
Cendón Franco, David Ángel +3 more
core +1 more source
Materials & DesignThe transmittance inhomogeneity of Tapered Optical Fibre Arrays (TOFAs) is well-recognized to attenuate edge signal, reduce detective sensitivity and compress dynamic response range.
Yuwen Xing +9 more
doaj +1 more source
Jurnal Kedokteran Gigi Universitas Padjadjaran, 2019 Pendahuluan:Salah satu alternatif bahan yang dapat digunakan untuk gigi tiruan cekat adalah Fiber Reinforced Composite (FRC) yaitu bahan yang berasal dari kombinasi fiber dan matriks resin.
Febriani Leni Purnamasari +2 more
doaj +1 more source
Over 30 W single-mode kilohertz-linewidth single-frequency all-fiber laser at 910 nm
High Power Laser Science and EngineeringPower scaling of neodymium (Nd)-doped single-frequency fiber lasers (SFFLs) operating at approximately 900 nm has been fundamentally constrained by dominant emission of approximately 1060 nm, with previous demonstrations limited to below 3 W.
Yafei Wang +11 more
doaj +1 more source
Soliton Molecules in Self-Mode-Locked Ring-Cavity Er/Yb Double-Clad Fiber Laser
IEEE Photonics Journal, 2019 In this paper, generation of soliton molecules by a self-mode-locked Er/Yb double clad fiber laser is experimentally demonstrated. The optical spectrum of the bound solitons exhibits eight well defined peaks at ∼1563 nm with high modulation
Manuel Duran-Sanchez +11 more
doaj +1 more source
Quantum Teknika, 2020 Blade design and material selection for savonius turbines need to accurate to produce high power input. This research aims to make the most robust blade material by vacuum infusion manufactured. The hybrid laminate composite applied in the manufacture of
Muhammad Abdus Shomad +2 more
doaj +1 more source
, 2010 The low-velocity impact behavior was studied in hybrid laminates manufactured by RTM with woven carbon and glass (S2) fabrics. Specimens with different thicknesses and glass fiber content (from 0 to 21 vol.%) were tested with impact energies in the range
Enfedaque Díaz, Alejandro
core +1 more source
Dispersion controlled highly nonlinear fibers for all optical processing at telecoms wavelengths [PDF]
, 2010 We review our recent progress in the development of lead silicate glass fibers with high nonlinearity and tailored near-zero dispersion at telecommunication wavelengths, encompassing holey, all-solid microstructured and W-type fiber designs.
Shi, Jindan +21 more
core +1 more source