Results 31 to 40 of about 598,020 (298)
A series of plasma innovation technologies by the double glow discharge phenomenon
AIP Advances, 2023 In order to break the limitation of plasma nitriding technology, which can only be applied to a few non-metallic gaseous elements, the “double glow discharge phenomenon” was defined and then the “double glow plasma surface metallurgy technology” was ...
Zhong Xu +7 more
doaj +1 more source
Applied Sciences, 2021 The low temperature plasma of glow discharge has found a widespread use as a heating source in welding and surface treatment of metals. The meticulous analysis of glow discharge’s instabilities in these processes allowed us to highlight the ...
Maksym Bolotov +3 more
doaj +1 more source
Numerical analysis of viscid compressible ionic flow [PDF]
, 2006 The aim of the paper is to investigate numerically the effect of a DC positive corona discharge between two parallel wire electrodes of different diameter along an insulating aerofoil surface in low subsonic compressible flow.
Tulita, C. +3 more
core +1 more source
INVESTIGATION OF COX REDUCTION SYSTEM PROTOTYPE AT 1000CC VEHICLE REMOVAL GASES USING KNIFE-TO-PLATE GLOW DISCHARGE PLASMA [PDF]
, 2004 COx reduction of exhaust gases from 1000cc vehicle has investigated using prototype reactor of corona glow discharge of plasma. Knife-to-plate electrodes configuration is used inside the reactor with DC high voltage source to generate corona glow ...
Suseno, Ahmad +2 more
core +1 more source
Nitriding of Long-Term Holes in the Cyclic-Commuted Discharge
Журнал інженерних наук, 2023 The effect of anhydrous nitriding in a glow discharge on microhardness, phase composition, and wear resistance of long holes in steels C45, 37Cr4, and 41CrAlMo7 with direct current supply and in cyclically switched discharge (CSD) was studied.
Stechyshyn M. +2 more
doaj +1 more source
Improvement of adhesive toughness measurement [PDF]
, 2011 The double cantilever beam (DCB) method for adhesive toughness measurement was improved by incorporating a sufficiently sharp crack made by a wedge-tapping method.
Meng, Qingshi +18 more
core +1 more source
Spatial characterization of pressure-based plasma regimes in a radiofrequency glow discharge by using optical emission spectroscopy [PDF]
, 2011 International audienceA new experimental set-up has been developed in order to perform spatially resolved measurements of the optical emission in a radiofrequency glow discharge (rf-GD). The emitted radiation is not only detected through an end-on window
Bordel García, Nerea +10 more
core +1 more source
The London, Edinburgh, and Dublin Philosophical Magazine and Journal of Science, 1895 n ...
openaire +1 more source
Frontiers in Physics, 2021 Discharge gases have been used to detect terahertz (THz) waves, however, there are few relevant theoretical studies. The neon glow discharge model is established by COMSOL Multiphysics software, the characteristics of glow discharged neon and the ...
Lei Hou +4 more
doaj +1 more source
Stm of Glow-Discharge Treated Surfaces [PDF]
Biomaterials, Artificial Cells and Immobilization Biotechnology, 1993 As a model surface, graphite slides were treated by pure nitrogen gas plasma for different periods (15 sec-5 min). These samples were kept in air or under argon atmosphere in sealed holders. STM images were obtained at constant current mode. Results showed that both the number and the size of clusters formed by plasma deposition increased with exposure
Oral, A. +3 more
openaire +3 more sources