Results 61 to 70 of about 147,870 (281)
Packaging of Macroscopic Material Payloads: Needs, Challenges, Concepts, and Future Directions
Advanced Engineering Materials, EarlyView.This review introduces a unified framework that decomposes any macroscopic packaging system into the payload, packaging material, and packaging strategy and combines them into a conceptual packaging equation: packaging strategy = payload + packaging material.
Venkata S. R. Jampani, Manos Anyfantakis
wiley +1 more source
THE EFFECT OF MAT MOISTURE CONTENT GRADIENT ON PHYSICAL & MECHANICAL PROPERTIES OF PARTICLEBOARD [PDF]
تحقیقات علوم چوب و کاغذ ایران, 2005 In this investigation, experimental boards were produced using beech wood particle, mat moisture content gradient at 0,3 and 6%, two press temperature sat 165and 1850 C and two press times at 3 and 5 minutes.
Abolfazl Kargarfard +4 more
doaj +1 more source
Advanced Engineering Materials, EarlyView.It is shown that laser ablation pretreatment under oxygen‐free conditions enables copper–aluminium bonding at significantly lower deformation degrees and improved properties compared to mechanical brushing. Laser ablation further increases interface contact area and induces favourable residual stress states and microstructural compatibility ...
Khemais Barienti +11 more
wiley +1 more source
Advanced Engineering Materials, EarlyView.Low‐cycle fatigue damage in Mn–Mo–Ni reactor pressure vessel steel is examined using a combined electron backscatter diffraction and positron annihilation lifetime spectroscopy approach. The study correlates texture evolution, dislocation substructure development, and vacancy‐type defect formation across uniform, necked, and fracture regions, providing
Apu Sarkar +2 more
wiley +1 more source
Advanced Engineering Materials, EarlyView.Stabilization of L‐PBF Ni50.7Ti49.3 under low‐cycle loading was investigated. Recoverable strain after cycling was dependent on the amount of applied load. Recovery ratio was 53.4% and 35.1% at intermediate and high load, respectively. The maximum total strain reached 10.3% at a high load of 1200 MPa.
Ondřej Červinek +5 more
wiley +1 more source
A gradient elasticity approach to the indentation size effect at very small depths
Journal of the Mechanical Behavior of Materials, 2011 Over the past two decades, the indentation size effect (ISE) has been studied extensively by several authors. A common point among all these studies has been the premise that during the indentation process sufficient plastic deformation is developed so ...
Mokios George P., Aifantis Elias C.
doaj +1 more source
Young measures supported on invertible matrices
, 2013 Motivated by variational problems in nonlinear elasticity depending on the deformation gradient and its inverse, we completely and explicitly describe Young measures generated by matrix-valued mappings $\{Y_k\}_{k\in\N} \subset L^p(\O;\R^{n\times n})$, $\
Benešová, Barbora +2 more
core +1 more source
Nanoindentation Criteria for Combinatorial Thin Film Libraries
Advanced Engineering Materials, EarlyView.Thin‐film material libraries are compositional spreads used for screening composition‐structure‐property relationships. Nanoindentation is often used to characterize mechanical behavior across these systems, however variations in methodology are widespread.
Andre Bohn, Adie Alwen, Andrea M. Hodge
wiley +1 more source
A note on gradient elasticity and nonsingular crack fields
Journal of the Mechanical Behavior of Materials, 2012 No abstract available.
Aifantis Elias C.
doaj +1 more source
Advanced Engineering Materials, EarlyView.A numerical–experimental framework is developed for characterizing multi‐matrix fiber‐reinforced polymers (MM‐FRPs) combining epoxy and polyurethane matrices. Harmonic bending tests are integrated with finite element model updating (FEMU) to simultaneously identify elastic and viscoelastic material parameters.
Rodrigo M. Dartora +4 more
wiley +1 more source