Results 131 to 140 of about 2,179,097 (304)
Extended grain filling has potential to improve yield in grain sorghum
Journal of Experimental BotanyAbstract Yield increase in sorghum has been achieved primarily by increasing grain number. Scope exists to increase yield by increasing grain size; however, this has been limited by the negative correlation between grain size and grain number. Extending the duration of the grain-filling period has potential to enable increased grain size
Daniel Otwani +8 more
openaire +4 more sources
Rapidly Solidified High‐Strength Invar 36 Prepared by Planar‐Flow Melt Spinning
Advanced Engineering Materials, EarlyView.The Invar 36 alloy was rapidly solidified using the planar‐flow melt‐spinning technique. Ribbon samples with thicknesses ranging from 20 to 160 mm were produced. As the grain size of the ribbon decreased to sub‐micron levels, the hardness increased by more than 2 times.
Bekir Akgül, Mehmet Kul
wiley +1 more source
Advanced Engineering Materials, EarlyView.Gallium microalloying redirects interfacial reactions in low‐temperature Bi–Sn solders from Cu–Sn toward Cu–Ga intermetallic formation. The resulting Cu–Ga layer suppresses intermetallic growth during thermal aging, alters fracture pathways, and improves interfacial stability.
Iva Králová +6 more
wiley +1 more source
VALUE OF INCREASING KERNEL UNIFORMITY [PDF]
Kernel uniformity is an important quality attribute that can now be measured at low cost. This study analyzes the profitability of sorting to increase wheat kernel uniformity.
Yoon, Byung-Sam +2 more
core
Effectiveness of different phytohormones on grain filling and yield of rice (Oryza sativa L.) under drought stress [PDF]
, 2014 Drought is a major limiting factor affecting rice yield and productivity all over the world, including Malaysia. To induce drought resistance, there is an increasing interest in using different phytohormones for field crop production considering its ...
M. Robiul Islam, +5 more
core +1 more source
Advanced Engineering Materials, EarlyView.HEA interlayers offer a versatile route for joining high‐performance structural materials. Their compositional and structural design regulates interfacial reactions, suppresses brittle IMCs, and improves metallurgical bonding. Sandwich interlayers further integrate defect healing with precipitation strengthening, enabling improved strength–ductility ...
Lin Yuan +4 more
wiley +1 more source
A Novel Approach to Estimate the Transition Temperature via Dynamic Nanoindentation
Advanced Engineering Materials, EarlyView.A new dynamic nanoindentation‐based method was developed that uses the stiffness ratio as an indicator of the elastic–plastic deformation contributions at different temperatures. The approach successfully identified transition temperatures in ferritic steel and distinguished them from continuously ductile austenitic steel.
Stefan Zeiler +4 more
wiley +1 more source
Effects of Mg on Microstructure and Solidification of a Hypereutectic Zn–8 wt.%Al Alloy
Advanced Engineering Materials, EarlyView.An appreciable set of results involving thermal data, microstructure, chemical composition, and microstructural growth laws is reported for ZnAlMg alloys. Such results demonstrate that ZnAlMg alloys have high potential for applications in automotive self‐lubricating components, batteries, and electrical systems.
Raí B. de Sousa +6 more
wiley +1 more source
Advanced Engineering Materials, EarlyView.Near‐surface deuterium enrichment profiles for different microstructural types of TiAl after exposure at 700 °C in a heavy water‐containing environment. The deuterium levels are significantly higher than expected from natural occurrence, indicating that the heavy water dissociated during the exposure treatment and entered the specimens.
Jonathan D. H. Paul +5 more
wiley +1 more source