Results 81 to 90 of about 1,191,943 (280)

The Effect of Boron (B) and Copper (Cu) on the Microstructure and Graphite Morphology of Spheroidal Graphite Cast Iron. [PDF]

open access: yesMaterials (Basel), 2023
Ha JS   +10 more
europepmc   +1 more source

Circularly Polarized Electroluminescence and Spin‐Polarized Carrier Transport in Chiral‐Doped Polymer Films

open access: yesAdvanced Functional Materials, EarlyView.
Chiral dopants induce supramolecular chirality in an achiral polymer (PFO), generating spin‐polarized carriers via the chiral‐induced spin selectivity (CISS) and suggesting a possible contribution of Spin‐polarized carrier transport to circularly polarized electroluminescence (CPEL).
Kazuyuki Asahi   +4 more
wiley   +1 more source

Fracture Morphology of Composite CBN Wheel Segments Based on Graphite Self-Lubricating Effects

open access: yes, 2011
Multilayer brazed CBN wheel segments based on graphite self-lubricating has been fabricated. The bending strength of wheel segments was measured and the fracture morphology of tested segments was detected.
Jiu Hua Xu   +3 more
core   +1 more source

Nitride MXenes Beyond Carbides: Bridging the Gap Between Computational Prediction and Experimental Realization

open access: yesAdvanced Functional Materials, EarlyView.
Nitride MXenes remain constrained by a persistent gap between computational prediction and experimental realization. This Review identifies the thermodynamic, kinetic, and chemical barriers limiting their synthesis, critically evaluates emerging fabrication routes, and proposes a multidimensional computational‐experimental framework to accelerate the ...
Naresh Varnakavi, Masoud Soroush
wiley   +1 more source

The tribological and wear properties of carbon-graphite composites [PDF]

open access: yes, 1994
A range of carbon-graphites with differing properties has been evaluated for wear resistance. These include carbons with a high degree of graphitic order (natural and synthetic graphite), those with little or no such order (pitch bonded cokes, glassy ...
J H Morris, Morris, Justin Howard
core   +1 more source

PLASTIC DEFORMATION OF GRAPHITE WHILE HEATING COMPOSITE POWDERS

open access: yesНаука и техника, 2011
The paper presents results of graphite surface morphology research and graphite structure improvement (density increase) in nano-coatings of iron alloy powders while making isothermal heating up to 1200 °С and plastic deformation caused by tensile stress
V. N. Kovalevsky   +5 more
doaj  

Few-Layer Graphene from Mechanical Exfoliation of Graphite-Based Materials: Structure-Dependent Characteristics

open access: yesChemEngineering, 2019
We present a high-scale method to produce few-layer graphene (FLG) based on the mechanical exfoliation of graphite and compare the obtained FLG with the one reported earlier arising from pencil lead ablation.
Azhar A. Pirzado   +6 more
doaj   +1 more source

Defect‐Free Transfer Principles for Scalable, Thin Garnet‐Based Hybrid Solid Electrolytes in Solid‐State Batteries

open access: yesAdvanced Functional Materials, EarlyView.
Defect‐free transfer principles enable scalable fabrication of 15 µm‐thin garnet‐based hybrid solid electrolytes. Hansen solubility parameters correlate interfacial compatibility with coating, transfer, and impregnation behavior, guiding rational selection of slurry/substrate, binder/substrate, and binder/polymer electrolyte combinations.
Seul Gi Chu   +8 more
wiley   +1 more source

Lewis Acid Site Engineering in MOF‐Derived Aluminum Oxide/Carbon Composites for Dechlorination of Waste Plastic Pyrolysis Oil

open access: yesAdvanced Functional Materials, EarlyView.
Controlled carbonization of an Al‐MOF partially decomposes its linkers, exposing coordinatively unsaturated Al centers within an oxide/carbon composite. The resulting Lewis acid sites, rather than surface area, govern organochlorine capture: the composite removes chemically diverse organochlorines from waste plastic pyrolysis oil, outperforms a ...
Seong Cheon Kim   +6 more
wiley   +1 more source

Halide Composition Controls Phase Morphology and Device Specific Performance in Perovskite Photovoltaics and Light Emitting Diodes

open access: yesAdvanced Functional Materials, EarlyView.
We demonstrate that halide composition determines phase morphology, governing distinct operating mechanisms in mixed halide perovskites. Phase segregating 75% Br compositions enhance solar cell performance, whereas intrinsically phase‐separated 95% Br compositions provide stable light emitting diodes.
Tal Binyamin   +6 more
wiley   +1 more source

Home - About - Disclaimer - Privacy