Microelectrode evaluation of in situ oxidant reactivity and pH variability at new ductile iron and copper coupon surfaces. [PDF]
Water Res, 2023 Lee WH +4 more
europepmc +1 more source
Advances in Materials Science and Engineering, 2015 While NaNO2 addition can greatly inhibit the corrosion of carbon steel and ductile cast iron, in order to improve the similar corrosion resistance, ca. 100 times more NaNO2 addition is needed for ductile cast iron compared to carbon steel.
K. T. Kim +5 more
doaj +1 more source
Microstructure and Dry/Wet Tribological Behaviors of 1% Cu-Alloyed Austempered Ductile Iron. [PDF]
Materials (Basel), 2023 Hsu CH, Lin CY, You WS.
europepmc +1 more source
Evaluation of producing technique factors affecting the matrix microstructure of as-cast ductile iron castings [PDF]
Metalurgija, 2011 The objective of this paper was to investigate some important parameters related to ductile iron matrix microstructure. Ductile iron round bars of various diameters in order to achieve various cooling rates were obtained in different conditions.
S. Bockus, G. Zaldarys
doaj
Pin-On-Disc Characterization of Brass/Ferritic and Pearlitic Ductile Iron Rubbing Pair
High Temperature Materials and Processes, 2011 Wear behaviour of special brass produced through two different methods (centrifugal and sand casting) was investigated. The wear tests were carried out at sliding velocities of 0.2 ms–1, 0.3 ms–1, 0.4 ms–1 and 0.5 ms–1 and under 10 N, 20 N, and 40 N ...
Çetin Melik
doaj +1 more source
Effect of Electric Pulse Treatment on Hot-Dip Aluminizing Coating of Ductile Iron. [PDF]
Materials (Basel), 2021 Dong J +5 more
europepmc +1 more source
Effect of the Biodegradable Component Addition to the Molding Sand on the Microstructure and Properties of Ductile Iron Castings. [PDF]
Materials (Basel), 2022 Major-Gabryś K +3 more
europepmc +1 more source
Abrasive Wear of Mining Chain Drums Made of Austempered Ductile Iron in Different Operating Modes. [PDF]
Materials (Basel), 2022 Wieczorek AN +5 more
europepmc +1 more source
Comparative study of TIG and SMAW root welding passes on ductile iron cast weldability
Metalurgija, 2017 This work compares the weldability of ductile iron when: (I) a root weld is applied with a tungsten inert gas (TIG) process using an Inconel 625 source rod and filler welds are subsequently applied using coated electrodes with 97,6%Ni; and (II) welds on ...
J. Cárcel-Carrasco +3 more
doaj
Insights into the Correlation between Residual Stresses, Phase Transformation, and Wettability of Femtosecond Laser-Irradiated Ductile Iron. [PDF]
Nanomaterials (Basel), 2022 Kumar D, Liedl G, Otto A, Artner W.
europepmc +1 more source