Results 61 to 70 of about 83,709 (298)
Power System Oscillations with Different Prevalence of Grid-Following and Grid-Forming Converters
Energies, 2022 The oscillatory behaviour of the power system is an aspect that is significantly affected by the increasing integration of converter-based generation sources.
Rossano Musca +2 more
doaj +1 more source
Full- & Reduced-Order State-Space Modeling of Wind Turbine Systems with Permanent-Magnet Synchronous Generator [PDF]
, 2018 Wind energy is an integral part of nowadays energy supply and one of the fastest growing sources of electricity in the world today. Accurate models for wind energy conversion systems (WECSs) are of key interest for the analysis and control design of ...
Hackl, Christoph M. +4 more
core +3 more sources
Harnessing Fungal Biowelding for Constructing Mycelium‐Engineered Materials
Advanced Engineering Materials, EarlyView.Mycelium‐bound composites (MBCs) offer low‐carbon alternatives for construction, yet interfacial bonding remains a critical challenge. This review examines fungal biowelding as a biocompatible adhesive, elucidating mycelium‐mediated interfacial mechanisms and their role in material assembly. Strategies to optimize biowelding are discussed, highlighting
Xue Brenda Bai +2 more
wiley +1 more source
Frontiers in Energy ResearchWhen the Grid-Following (GFL) and the Grid-Forming (GFM) converters are hybrid-connected to the grid, they are coupled through the grid impedance. During grid faults, the transient characteristics of the two converters become more complex due to this ...
Baoyu Zhai +5 more
doaj +1 more source
Grid Forming Control for Power Converters Based on an Inertial Phase Locked Loop (IPLL)
IEEE Access, 2023 Inertia emulation is claimed to play a decisive role in the regulation and management of frequency in modern electrical systems. The support offered by renewable energy power plants and distributed generators is key to diminish the rate of change of ...
Andres Tarraso +4 more
doaj +1 more source
Advanced Engineering Materials, EarlyView.This study presents an infrared monitoring approach for direct laser interference patterning (DLIP) combined with a convolutional neural network (CNN). Thermal emission data captured during structuring are used to predict surface topography parameters.
Lukas Olawsky +5 more
wiley +1 more source
Dynamic Interaction and Stability Analysis of Grid-following Converter Integrated Into Weak Grid
CSEE Journal of Power and Energy SystemsThe grid-connected converter with grid-following control (GCC-GFL) for renewable energy sources has a risk of instability when integrated into the weak grid. This paper aims to investigate the dynamic interactions and stability characteristics of the GCC-
Shuang Li +5 more
doaj +1 more source
, 2015 This paper deals with the problem of trajectory tracking of a class of bilinear systems with time--varying measurable disturbance. A set of matrices {A,B_i} has been identified, via a linear matrix inequality, for which it is possible to ensure global ...
Bergna, G. +5 more
core +4 more sources
Impedance-compensated grid synchronisation for extending the stability range of weak grids with voltage source converters [PDF]
, 2016 This paper demonstrates how the range of stable power transfer in weak grids with voltage source converters (VSCs) can be extended by modifying the grid synchronisation mechanism of a conventional synchronous reference frame phase locked loop (PLL).
D'Arco, Salvatore +3 more
core +2 more sources
Advanced Engineering Materials, EarlyView.Stabilization of L‐PBF Ni50.7Ti49.3 under low‐cycle loading was investigated. Recoverable strain after cycling was dependent on the amount of applied load. Recovery ratio was 53.4% and 35.1% at intermediate and high load, respectively. The maximum total strain reached 10.3% at a high load of 1200 MPa.
Ondřej Červinek +5 more
wiley +1 more source