Results 71 to 80 of about 83,709 (298)

Stability Analysis and Enhanced Control of Wind Turbine Generators Based on Hybrid GFL-GFM Control

Energies
With the proliferation of wind power generation, the receiving end grids exhibit unprecedented dynamic characteristics, imposing critical stability challenges on grid-connected wind turbine’s converter.
Sijia Huang, Zhenbin Zhang, Zhihao Chen, Huimin Huang, Zhen Li   +4 more
doaj   +1 more source

Operation and control of a current source converter series tapping of an LCC-HVDC link for integration of offshore wind power plants [PDF]

, 2016
This work presents a series tapping station for integrating Offshore Wind Power Plants (OWPP) into a (Line Commutated Converter High Voltage Direct Current) LCC-HVDC transmission system.
Galceran Arellano, Samuel, Gomis Bellmunt, Oriol, Prieto Araujo, Eduardo, Sau Bassols, Joan   +3 more
core   +2 more sources

EBSD Study of Creep‐Induced Lattice Misorientation in MgO‐Particle‐Reinforced Austenitic Steel Composites

Advanced Engineering Materials, EarlyView.
Creep experiments at 900°C on coarse‐grained steel‐ceramic composites containing recycled magnesia reveal that higher ceramic volume fractions significantly enhance the creep resistance. Detailed EBSD investigations identify subgrain formation in the steel matrix as the dominant deformation mechanism.
Moritz Müller, Amaya Compart, Mahnaz Mehdizadehlima, Serhii Yaroshevskyi, Christos G. Aneziris, Horst Biermann, Anja Weidner   +6 more
wiley   +1 more source

Dynamic interaction analysis of grid-following and grid-forming hybrid system based on phase angle response

International Journal of Electrical Power & Energy Systems
Grid-following (GFL) converters potentially reduce the inertia and damping of the power system, thereby weakening the grid. Deploying grid-forming (GFM) converters can effectively enhance grid strength and improve system dynamic performance. However, due
Yong Yan, Bin Wang, Liangli Zhang, Ruohan Gong, Wanwan Xu   +4 more
doaj   +1 more source

Four‐Point Bending Tests at High Temperatures on Commercial MgO‐C Refractory Bricks with and Without Recyclate Considering Different Carbon Contents

Advanced Engineering Materials, EarlyView.
Four‐point bending tests are conducted in an argon atmosphere on commercial MgO‐C brick grades with and without MgO‐C recyclate from room temperature up to 1300 °C. No detrimental effect of the MgO‐C recyclates on bending strength is found. Instead, a decisive influence of the total carbon content is observed, with lower total carbon contents ...
Alexander Schramm, Lukas Knöchel, Thomas Schemmel, Christos G. Aneziris, Anja Weidner, Horst Biermann   +5 more
wiley   +1 more source

A cooperative control strategy for power quality based on parallel grid-connected converters

电力工程技术
Power quality control based on grid-connected converter can effectively utilize the surplus capacity of the converter and improves the benefits. However, existing methods tend to only consider grid-following (GFL) control and fail to fully utilize the ...
LIANG Xiaorui, LUO Yuhang, ZHANG Huaying, TU Chunming, LIU Huicong, ZHENG Yuting   +5 more
doaj   +1 more source

Oscillation Suppression of Grid-Following Converters by Grid-Forming Converters with Adaptive Droop Control

Energies
The high penetration of renewable energy sources (RESs) and power electronics devices has led to a continuous decline in power system stability. Due to the instability of grid-following converters (GFLCs) in weak grids, the grid-forming converters (GFMCs) have gained widespread attention featuring their flexible frequency and voltage regulation ...
Lifeng Qiu, Miaosong Gu, Zhongjiang Chen, Zhendong Du, Ligang Zhang, Wenrui Li, Jingyi Huang, Jingyang Fang   +7 more
openaire   +2 more sources

Assessing Altered Coating Adhesion on Plasma‐Deoxidized Surfaces Under Oxygen‐Free Conditions

Advanced Engineering Materials, EarlyView.
This study demonstrates the effectiveness of atmospheric pressure plasma pretreatment in modifying silicon and stainless steel surfaces to improve adhesion. Argon‐hydrogen plasma increases surface roughness and improves adhesion strength, whereas pure argon results in smoother surfaces and structural changes.
Selina Raumel, Lara Kuhr, Khemais Barienti, Sebastian Herbst, Florian Nürnberger, Hans Jürgen Maier, Marc C. Wurz   +6 more
wiley   +1 more source

Performance Evaluation of Fuel Cell and Microturbine as Distributed Generators in a Microgrid [PDF]

, 2009
This paper presents dynamic models of distributed generators (DG) and investigates dynamic behaviour of the DG units within a microgrid system. The DG units include micro turbine, fuel cell and the electronically interfaced sources.
Mohamed , Azah, Nizam , Muhammad, Salam , A.A.   +2 more
core  

Power Quality Improvement Wind Energy System Using Cascaded Multilevel Inverter [PDF]

, 2013
In this paper, a wind energy conversion system based on a cascaded H-bridge multilevel inverter (CHBMLI) topology has been proposed to be used for the grid interface of large split winding alternators (SWAs).
A. S., Kumar, J.S., Sathiyanarayanan
core   +2 more sources