Results 11 to 20 of about 18,465 (303)
Unified Virtual Oscillator Control for Grid-Forming and Grid-Following Converters [PDF]
A unified virtual oscillator controller (uVOC) is proposed, which enables a unified analysis, design, and implementation framework for both grid-forming (GFM) and grid-following (GFL) voltage source converters (VSCs). Oscillator based GFM controllers, such as dispatchable virtual oscillator control (dVOC), offer rigorous analytical framework with ...
M. A. Awal, Iqbal Husain
openaire +2 more sources
Synchronous Fault Compensator for Voltage Sensorless Grid-Following Power Converters
During the last decade, the penetration of grid-connected RES systems has been in constant increase, forcing those systems interfaced to the electrical grid to improve and design new advanced controllers to maintain the power converter under control. The most extended control for grid-tied inverters is the so-called grid-following control.
Tarraso Martínez, Andrés +2 more
openaire +2 more sources
Analysis of X/R Ratio Effect on Stability of Grid-Following and Grid-Forming Converters [PDF]
The power system is undergoing significant changes with the increasing integration of renewable energy sources, such as wind and solar. The high penetration of these renewable energy sources has posed new challenges on the stability of the power grid. In
Anvari-Moghaddam, Amjad; id_orcid +3 more
core +1 more source
Grid-following and grid-forming PV and wind turbines
As penetration of photovoltaic (PV) and wind generation systems driven by grid-connected power converters monotonously increases, unusual interactions between innovative and legacy generation systems become more concerning, since they threaten the system
Rodríguez Cortés, Pedro, Lai, Ngoc Bao
core +1 more source
With increasing shares of wind and/or solar power in many power systems, the possibility of a 100% power converter‐based system becomes more likely. Consequently, the dynamic response of the Irish transmission systems with 100% (grid‐following and grid ...
Xianxian Zhao, Damian Flynn
doaj +1 more source
Influence of Load Dynamics on Converter-Dominated Isolated Power Systems
The operation of isolated power systems with 100% converter-based generation requires the integration of battery energy storage systems (BESS) using grid-forming-type power converters.
José Gouveia +2 more
doaj +1 more source
Equivalent Active Distribution Networks Considering Grid Forming Converters
S.527-531Converters connected to distribution networks play an increasingly important role in the generation mix. Especially grid forming converters providing inertia to the system are vital to handle critical events in a converter dominated system. Thus,
Hendrik Lens +7 more
core +1 more source
Grid‐forming requirements based on stability assessment for 100% converter‐based Irish power system
The fault response of a 100% converter‐based system can be significantly different to that of a synchronous generator‐based system, considering the lower capacity headroom, but flexible control capability, of power electronic converters.
Xianxian Zhao +2 more
doaj +1 more source
Impact of Digital Control Delay on Stability of Grid-Following Converters
In a digital controlled system, the delay is inevitable. It will change the phase-frequency characteristics of the system, which will affect the stability. This paper analyzes the configuration of the grid-following converter and builds its small-signal model in detail.
Xian Gao +3 more
openaire +2 more sources
Robust repetitive feedback control of a three-phase grid connected inverter [PDF]
This paper discusses the design of a repetitive feedback controller for a grid-connected two-level three-phase voltagesource inverter connected between a DC source and the grid through an LCL filter.
Sharkh, S.M. +8 more
core +1 more source

