Results 111 to 120 of about 23,542 (164)

Lapping of Soft-Brittle Lithium Niobate Crystal with Fixed Abrasive Pad. [PDF]

Materials (Basel)
Zhu N, Gao X, Tang C, Chen J, Zhu Y.
europepmc   +1 more source

The Meaning of Mangabey Molars (And Premolars). [PDF]

Evol Anthropol
Guatelli-Steinberg D, Scott McGraw W.
europepmc   +1 more source

Research on precise modeling and grinding methods for full tooth surfaces of nonorthogonal face gears. [PDF]

Sci Rep
Zhengyang H, Chuang J, Xiaozhong D, Jianxin S, Julong Y, Yanzhen Z.   +5 more
europepmc   +1 more source

Recent Advances in Precision Diamond Wheel Dicing Technology. [PDF]

Micromachines (Basel)
Chen F, Du M, Feng M, Bao R, Jing L, Hong Q, Xiao L, Liu J.   +7 more
europepmc   +1 more source

Mechanochemical engineering of chiroptical properties in indium-based chiral metal halides by grinding. [PDF]

Nat Commun
Wu J, Li H, Wang J, Yang X, Zhang T, Li B, Jiang S.   +6 more
europepmc   +1 more source

Analysis of Subsurface Damage Based on K9 Glass Grinding. [PDF]

Materials (Basel)
Liu Y, Xie J, Li R, Gao J, Li M, Sun L.
europepmc   +1 more source

Some of the next articles are maybe not open access.

Related searches:

Experimental studies on grinding forces and force ratio of the unsteady-state grinding technique

Journal of Materials Processing Technology, 2002
Abstract The whole machining process of unsteady-state grinding was evaluated through the measurement of the grinding forces, namely tangential grinding force Ft and normal grinding force Fn. A number of accurate signals of the grinding forces were achieved by setting up a measurement system including a sensor, an amplifier, an oscilloscope and a ...
Binshan Lin
exaly   +4 more sources

Force controlled robot for grinding

IEEE International Workshop on Intelligent Robots and Systems, Towards a New Frontier of Applications, 2002
Two algorithms for use in force controlled robot applications have been developed for grinding. The 'gradient prediction method' is presented as an improvement to contour following in the force control mode. In this method, the gradient of the workpiece is predicted, and the force errors caused thereby are corrected.
Kunio Kashiwagi, Kozo Ono, Eiki Izumi, Tohru Kurenuma, Kazuyoshi Yamada   +4 more
openaire   +1 more source

Grinding Forces and Energy

Journal of Engineering for Industry, 1988
Grinding forces and energy play an important role in all abrasive machining operations. While specific grinding energy may be obtained from workpiece dynamometer values or by measuring spindle power, care must be exercised in converting dynamometer reading into power consumed.
K. Brach, D. M. Pai, E. Ratterman, M. C. Shaw   +3 more
openaire   +1 more source