Results 1 to 10 of about 2,858,375 (353)
Overvoltages in MV Industrial Grid under Ground Faults
Medium voltage distribution power grids mostly operate with ungrounded neutral points of transformers. The philosophy of these electrical grids is based on the assumption that they are more reliable than grids with grounded neutral.
Yuriy Varetsky
doaj +2 more sources
The faults occurring in different phases at multiple locations and different times are difficult to locate exact location using conventional techniques.
A Naresh Kumar, M Chakravarthy
doaj +2 more sources
The requirements for the increased penetration of renewable energy sources in electrical power systems have led to a dominance of power electronic interfaces.
Luis Santiago Azuara Grande +2 more
semanticscholar +1 more source
Development of new deposits and modernization of existing mining enterprises in order to improve their efficiency are the priorities for the development of tungsten-molybdenum resource sector. In the modernization of mining productions, attention is paid
R. V. Klyuev +3 more
doaj +1 more source
To solve the problem of the location of the fault point of single-pole-to-ground faults in the transmission lines of MMC-HVDC systems, this paper designs a fault location system based on support vector machine (SVM).
Jian-Yu Wu +3 more
doaj +1 more source
As a result of small fault current, high level of noise and a large penetration of distributed generators (DG), in the neutral non-effectively grounded medium-voltage (MV) distribution networks, it is quite difficult to locate the faulted line section ...
Xuewen Wang +6 more
semanticscholar +1 more source
Building fault detection data to aid diagnostic algorithm creation and performance testing. [PDF]
It is estimated that approximately 4-5% of national energy consumption can be saved through corrections to existing commercial building controls infrastructure and resulting improvements to efficiency.
Chen, Yan +4 more
core +2 more sources
Protective relays in electric power grids recognize the types of electrical faults in a few seconds. The most common detection method to detect the types of electrical faults is based on measuring the angle between the zero and negative sequence currents.
Emilio C. Piesciorovsky +1 more
doaj +1 more source
Fault Identification of DC Transmission Lines Based on Energy Ratio Analysis
HVDC transmission lines, being long in distance and crossing complex natural environments, are prone to lightning and short to ground faults. Aiming at this problem, a novel fault identification method is proposed based on energy ratio.
Peng ZHU +9 more
doaj +1 more source
Strong ground motions caused by earthquakes with magnitudes ranging from 3.5 to 6.9 and hypocentral distances of up to 300 km were recorded by local broadband stations and three-component accelerograms within Georgia’s enhanced digital seismic network ...
Nato Jorjiashvili +4 more
doaj +1 more source

