Results 11 to 20 of about 1,664,143 (290)
Crack Detection of Threaded Steel Rods Based on Ultrasonic Guided Waves [PDF]
Fatigue cracks are typical damage of threaded steel rods under dynamic loads. This paper presents a study on ultrasonic guided waves-based, fatigue-crack detection of threaded rods.
Kunhong Peng +4 more
doaj +2 more sources
Analysis of Bonding Defects in Cementing Casing Using Attenuation Characteristic of Circumferential SH Guided Waves [PDF]
Circumferential guided wave detection technology can serve as an alternative method for detecting casing bond defects. Due to the presence of the cement cladding, the circumferential SH guided waves transmit shear waves into the cement cladding as they ...
Jie Gao +5 more
doaj +2 more sources
Axial Stress Measurement of Steel Tubes Using Ultrasonic Guided Waves [PDF]
Axially loaded steel tubes are widely used as primary structural members in civil engineering structures. In this paper, a stress measurement method for axially loaded steel tubes is developed based on the linear relationship between the group velocity ...
Siyuan Zhu +3 more
doaj +2 more sources
Damage Monitoring of Steel Bars Based on Torsional Guided Waves [PDF]
Ultrasonic guided waves represent a new development in the field of non-destructive testing. Longitudinal guided waves are mostly used to monitor the damage of steel bars, but the received signal is usually degraded and noisy owing to its dispersive ...
Zhupeng Zheng, Zihao Zhang, Cheng Huang
doaj +2 more sources
Guided Circumferential Waves in Layered Poroelastic Cylinders [PDF]
The present paper investigates the propagation of time harmonic circumferential waves in a two-dimensional hollow poroelastic cylinder with an inner shaft (shaft-bearing assembly).
S.A. Shah, G. Apsar
doaj +2 more sources
Signal processing methods for defect detection in multi-wire helical waveguides using ultrasonic guided waves [PDF]
This thesis was submitted for the degree of Master of Philosophy and awarded by Brunel University LondonNon-Destructive Testing of industrial components carries vital importance, both financially and safety-wise.
Yucel, Mehmet Kerim
core +7 more sources
International audienceIn leading-edge industrial applications, assessing structure integrity is an important aspect of safety requirements. Structural Health Monitoring (SHM) proposes to use sensors and signal processing units in situ.
Imperiale, Alexandre +3 more
core +6 more sources
In recent years, there has been increasing attention on the development of non-destructive evaluation (NDE) methods using guided waves for long-length materials such as thin plates and pipes.
Takahiro Saitoh
doaj +1 more source
Two experiments, with differing equipment setups, were used to test rock bolts, with differing structures and grouting qualities, using low frequency (20–200 kHz) and high frequency (700 kHz-3 MHz) guided waves to determine the effect of grouting quality
Peng Li, Changsuo Zhang, Guanlin Yang
doaj +1 more source
Classification of solutions for guided waves in fluid-loaded viscoelastic composites with large numbers of layers [PDF]
Guided ultrasonic waves are used for the inspection of multilayered composite aerospace structures. Calculating the corresponding dispersion diagrams is challenging for thick-walled composites with more than 100 layers, such as in modern rocket booster ...
Armin M. A. Huber, Huber, Armin
core +1 more source

