Results 141 to 150 of about 13,352 (253)
Conventional single‐gradient freeze‐casting typically produces unidirectional porous architectures with limited transverse connectivity. The Sequential Hybridization by Infiltration and Freeze‐casting Technique (SHIFT) addresses this constraint by integrating secondary aligned structures within a preformed primary scaffold.
Kiho Sung, Sungchul Shin
wiley +1 more source
Synergistic effects of hard anodizing parameters on the microstructural, mechanical, and tribological properties of 6061 aluminum alloy. [PDF]
Behzadifar J, Najafi Y, Nazarizade B.
europepmc +1 more source
Slicing of Hard and Brittle Materials by Minimum Quantity Slurry
Katta, Hiroki +5 more
openaire +1 more source
Continuous wet‐spinning of PANI with TeNWs yields a multifunctional microfiber. Oriented TeNWs impose chain alignment and enhance π‐electron delocalization, boosting the Seebeck coefficient to 59.9 µV K−1 for passive temperature sensing (1 K detection limit), while achieving high pH sensitivity (59.25 mV pH−1) and rapid NH3 response (0.96 s).
Dongmei Xie +10 more
wiley +1 more source
Transient Liquid Phase Bonding of Hastelloy X with Inconel 738 Superalloy Using BNi-2 Interlayer: Microstructure and Mechanical Properties. [PDF]
Yang L +7 more
europepmc +1 more source
Umbilical cord stem cell‐derived exosomes encapsulated in an immunomodulatory bioadhesive hydrogel spray enable localized therapy, sustained vesicle delivery, macrophage polarization, suppress systemic inflammation, and mitigate glucose and insulin homeostasis impairments in MAFLD.
Triya Saha +4 more
wiley +1 more source
The Transition from Strain Softening to Strain Hardening in Metallic Glasses. [PDF]
Wang Y, Zheng G, Li M.
europepmc +1 more source
A novel PR strategy was proposed to improve CBD‐derived Sb2S3 film quality. It synergistically optimized the CBO of CdS/Sb2S3 interface and the back‐contact barrier, while the VS2 donor defect was converted into SSb2 acceptor defect with lower concentration.
Yeyang Lin +8 more
wiley +1 more source
Enhanced Resistance to Sliding and Erosion Wear in HVAF-Sprayed WC-Based Cermets Featuring a CoCrNiAlTi Binder. [PDF]
Zhang L +7 more
europepmc +1 more source
This study demonstrates that thermally evaporated lithium anodes combined with LiF passivation provide a high‐performance thin anode design for next‐generation ASSBs. This approach increases the critical current density from 1.6 to 2.6 mA cm−2, enabling full cells to achieve over 500 and 300 cycles at 1.5 and 3 mA cm−2, respectively, outperforming even
Jinsong Zhang +4 more
wiley +1 more source

