Evaluation of the true-strength characteristics for isotropic materials using ring tensile test
Nuclear Engineering and Technology, 2021 The paper proposes a technique for reconstructing the true hardening curve of isotropic materials from ring tensile tests. Neutron irradiated 42XNM alloy tensile properties were investigated.
A.S. Frolov, I.V. Fedotov, B.A. Gurovich
doaj +1 more source
A Micromechanical Model of Hardening, Rate Sensitivity and Thermal Softening in BCC Single Crystals [PDF]
, 2001 The present paper is concerned with the development of a micromechanical model of the hardening, rate-sensitivity and thermal softening of bcc crystals. In formulating the model we specifically consider the following unit processes: double-kink formation
Cuitino, Alberto M. +2 more
core +4 more sources
Science and Technology of Advanced Materials: Methods, 2022 Instrumented indentation testing is an efficient approach for measuring mechanical properties such as equivalent elastic modulus and hardness. Recently, the indentation-based approach has been extended to estimate the stress–strain curve corresponding to
Ta-Te Chen, Ikumu Watanabe
doaj +1 more source
Mg-3Al-1Zn alloy deformed along different strain paths: Role of latent hardening
Journal of Magnesium and Alloys, 2023 The mechanical properties of magnesium alloy AZ31 were investigated experimentally with visco-plastic self-consistent modeling. Tension, compression and plane strain compression (PSC) tests were performed along 3 directions of a hot rolled plate, and the
Yao Cheng +4 more
doaj +1 more source
Strain range dependent cyclic hardening of 08Ch18N10T stainless steel-experiments and simulations [PDF]
, 2019 This paper describes and presents an experimental program of low-cycle fatigue tests of austenitic stainless steel 08Ch18N10T at room temperature. The low-cycle tests include uniaxial and torsional tests for various specimen geometries and for a vast ...
Fumfera, Jaromír +4 more
core +1 more source
Materials & DesignNanolaminated materials have garnered considerable attention due to their high strength, elevated strain hardening rate, and measurable plasticity. The heightened strain hardening rate is attributed to the presence of back stress resulting from plastic ...
Benjie Ding +6 more
doaj +1 more source
Mechanical and forming properties of AA6xxx sheet from room to warm temperatures [PDF]
, 2010 The influence of temperature on the mechanical behaviour of the heat treatable Aluminium alloy EN AW-6061 has been investigated with a series of tensile tests.
Boogaard, Ton van den +4 more
core +1 more source
Numerical simulation of the mechanical response during strain path change: application to Zn alloys. [PDF]
The microstructure-based hardening model (Beyerlein and Tome, 2007), that accounts for the dislocation reversal-related mechanisms and the cut-through effect, is extended to HCP metals.
Barlat, F +4 more
core +1 more source
Constitutive behaviour of the metastable stainless steel: Sandvik Nanoflex [PDF]
, 2004 This article presents a model to describe the constitutive behaviour of corrosion-resistant Sandvik steel NanoflexTM [1] during metal forming and hardening. This material is characterised by different phenomena.
Datta, K., Huetink, J., Post, J.
core +3 more sources
Phenomenological Modeling of Deformation-Induced Anisotropic Hardening Behaviors: A Review
Metals, 2023 Numerous studies indicate that the hardening behaviors of materials are closely related to their deformation history. In the forming processes with loading path changes, such as sheet metal forming, anisotropic hardening behaviors are universally ...
Huachao Yang +3 more
doaj +1 more source