Results 101 to 110 of about 508,157 (301)
Journal of the American Philosophical Association, 2017 ABSTRACT:What makes a choice hard? I discuss and criticize three common answers and then make a proposal of my own. Paradigmatic hard choices are not hard because of our ignorance, the incommensurability of values, or the incomparability of the alternatives. They are hard because the alternatives are on a par; they are comparable, but one is not better
openaire +2 more sources
Consumed by Abdominal Distention
Arthritis Care &Research, EarlyView.
Abimbola Fadairo‐Azinge +3 more
wiley +1 more source
Packaging of Macroscopic Material Payloads: Needs, Challenges, Concepts, and Future Directions
Advanced Engineering Materials, EarlyView.This review introduces a unified framework that decomposes any macroscopic packaging system into the payload, packaging material, and packaging strategy and combines them into a conceptual packaging equation: packaging strategy = payload + packaging material.
Venkata S. R. Jampani, Manos Anyfantakis
wiley +1 more source
Nihon Kikai Gakkai ronbunshuSince it is known that tensile strength and hardness are roughly proportional, a hardness test is often used as a simple and substitute test. However, it has been reported that the proportional relationship between tensile strength and hardness is broken
Yuta MIZUNO +3 more
doaj +1 more source
Advanced Engineering Materials, EarlyView.High‐temperature interactions between low‐sulfur Al‐killed Mn–B steel and MgO–C refractories (0 and 50 wt% recyclates) are studied via finger immersion tests (1600 °C). Surface‐active elements influence infiltration. MgO/CaS layer forms, along with spinel and calcium silicate.
Matheus Roberto Bellé +5 more
wiley +1 more source
, 2015 A low-density, nanocrystalline high-entropy alloy, Al20Li20Mg10Sc20Ti30 was produced by mechanical alloying. It formed a single-phase fcc structure during ball milling and transformed to single-phase hcp upon annealing.
K. Youssef +4 more
semanticscholar +1 more source
Advanced Engineering Materials, EarlyView.It is shown that laser ablation pretreatment under oxygen‐free conditions enables copper–aluminium bonding at significantly lower deformation degrees and improved properties compared to mechanical brushing. Laser ablation further increases interface contact area and induces favourable residual stress states and microstructural compatibility ...
Khemais Barienti +11 more
wiley +1 more source
Advanced Engineering Materials, EarlyView.This study investigates the tribological response of 60NiTi alloy under dry, water‐lubricated and high‐temperature conditions. The alloy exhibits decreasing wear volume and friction with increasing temperature due to the formation of protective oxide layers. The work clarifies dominant wear mechanisms and demonstrates the suitability of 60NiTi for high‐
Anthony Onyebuchi Okoani +2 more
wiley +1 more source
Fenmo yejin jishuFe–Mn–P–C non-magnetic steel balance block parts were prepared by pressing-sintering method by adding Fe3P powders and graphite powders in different mass fraction to the high manganese steel alloy powders.
BAO Chongxi +3 more
doaj +1 more source
Advanced Engineering Materials, EarlyView.Creep experiments at 900°C on coarse‐grained steel‐ceramic composites containing recycled magnesia reveal that higher ceramic volume fractions significantly enhance the creep resistance. Detailed EBSD investigations identify subgrain formation in the steel matrix as the dominant deformation mechanism.
Moritz Müller +6 more
wiley +1 more source