Results 91 to 100 of about 1,693 (205)
Photocatalytic Water Splitting on the Lunar Surface: Prospects for In Situ Resource Utilization
Water has been found in craters on the moon nearby locations which are illuminated >80% of the time. Photocatalysis uses energy from sunlight to drive chemical reactions such as water splitting to produce oxygen and hydrogen. It is a scalable technology that requires lighter equipment and utilizes resources available on the moon. ABSTRACT The discovery
Ranjani Kalyan +6 more
wiley +1 more source
The use of a photoionization detector to detect harmful volatile chemicals by emergency personnel
Neil D Patel1, William D Fales1, Robert N Farrell1,21Michigan State University, Kalamazoo Center for Medical Studies, Kalamazoo, MI, USA; 2Portage Fire Department, Portage, MI, USAObjective: The objective of this investigation was to determine ...
Neil D Patel +2 more
doaj
Surface‐Anchored Microgel‐Based Films as Anti‐Icing Coatings
The microgel‐based anti‐icing coatings presented in this work reduce ice adhesion by up to 90% on various substrates. This effect can be attributed to the incorporated functional cationic moieties binding a lubricating layer of quasi‐liquid interfacial water.
Inga Litzen +9 more
wiley +1 more source
Low‐Temperature Gold Deposition Improves CdTe Back Contacts
Cd(Se,Te) samples are cooled during the evaporation of Au back contacts to thermally quench CdTe degradation. Reduced temperature during Au evaporation boosts PV efficiency, open‐circuit voltage, and fill factor. XPS associates these improvements with less chemical perturbation of the CdTe surface during metallization.
Christopher P. Muzzillo +5 more
wiley +1 more source
ABSTRACT Molybdenum disulfide (MoS2) has attracted attention as a promising material due to the growing demand for environmentally friendly, cost‐effective, and efficient water treatment techniques. With its physicochemical characteristics, this stratified bidimensional material allows it to be highly effective in adsorption and catalytic performance ...
Pariksha Bishnoi +4 more
wiley +1 more source
Fully Printed Electrocaloric Heat Pump
A system based on a flexible printed PEDOT:PSS/P(VDF‐TrFE‐CFE) electrocaloric membrane. The membrane periodically alternates between the cold and hot sides following its electrocaloric cycle and successfully generates a temperature difference. The entire fabrication process is industrially scalable, cost‐effective, and based on widely accessible ...
Adrian Agreda +7 more
wiley +1 more source
Programmable luminescent tags based on organic room‐temperature phosphorescence are shown to be governed by oxygen incorporation during fabrication. Oxygen‐free processing enables immediate phosphorescence activation, controlled thermal preconditioning, and tunable activation doses.
Lucy Winkler +2 more
wiley +1 more source
Harmful Chemicals in the Environment: Measurement, Fate, and Remediation
Jian Lu +4 more
doaj +1 more source
Permanent magnet putty (PMP) integrates high‐coercivity NdFeB particles with a dynamic polyborosiloxane–Ecoflex matrix, achieving rapid self‐healing (90% mechanical recovery in 10 s) and magnetic recovery within 20 min. With twice the sensitivity of commercial putties, PMP enables precise 5–30 N force detection and discrimination between pressing and ...
Ruotong Zhao +5 more
wiley +1 more source
Machine Learning for Green Solvents: Assessment, Selection and Substitution
Environmental regulations have intensified demand for green solvents, but discovery is limited by Solvent Selection Guides (SSGs) that quantify solvent sustainability. Training a machine learning model on GlaxoSmithKline SSG, a database of sustainability metrics for 10,189 solvents, GreenSolventDB is developed. Integrated with Hansen solubility metrics,
Rohan Datta +4 more
wiley +1 more source

