Results 141 to 150 of about 688,148 (407)
Advanced Engineering Materials, EarlyView.This study explores the ablation efficiency and surface quality of laser‐treated stainless steel alloys (AISI 304, AISI 420, and AISI 316Ti) using an ultrashort pulsed laser and varying burst parameters (MHz, GHz, and Bi‐burst). Both ablation rates and surface quality parameters are determined, including isotropy surface roughness values, highlighting ...
Dirk Obergfell +2 more
wiley +1 more source
AcousticsCurrently, ultrasonic methods for assessing the fatigue lifetime of various structural materials are being actively developed. Many steel constructions are made by welding.
Alexander Gonchar +2 more
doaj +1 more source
Characterization of Microstructural Evolution in Heat-Affected Zone of Cu-Bearing Ultra-High-Strength Steel with Lamellar Microstructure. [PDF]
Materials (Basel), 2023 Fang C, Li C, Ji F, Fu W, Hu W, Di X.
europepmc +1 more source
Numerical Modeling of Heat-Affected Zone in GMAW Process
, 2021 ABSTRACTLow-carbon steel St37-2 is widely used in the bus production industry. The gas metal arc welding (GMAW) is strongly applied to join steel components due to its ease and low cost. Heat-affected zone (HAZ) is the area between the weld and base metal where can have the lowest toughness in a welding joint and hence it has always been a matter of ...
openaire +1 more source
Room temperature crack growth rates and -20 deg F fracture toughness of welded 1 1/4 inch A-285 steel plate [PDF]
Data are presented which were developed in support of a structural assessment of NASA-LEWIS' 10-foot by 10-foot supersonic wind tunnel, critical portions of which are fabricated from rolled and welded 1 1/4 inch thick A-285 steel plate. Test material was
Rzasnicki, W., Shannon, J. L., Jr.
core +1 more source
Crack emanation from defects modelled by extremely small drilled holes in two conditions [PDF]
, 2006 Fatigue is the primary reason for the failure of structural components. Resistivity of a coarse grain heat affected zone against fatigue crack initiation in presence of micro-defects is discussed in the present article.
Gliha, V. +5 more
core
Underlying burning resistant mechanisms for titanium alloy
, 2018 The "titanium fire" as produced during high pressure and friction is the major failure scenario for aero-engines. To alleviate this issue, Ti-V-Cr and Ti-Cu-Al series burn resistant titanium alloys have been developed. However, which burn resistant alloy
Bo, Arixin +8 more
core +1 more source
Advanced Engineering Materials, EarlyView.This study developed a two‐step laser‐based process for sustainable surface treatment of Ti–6Al–4 V components, combining laser polishing and direct laser interference patterning with ns and ps pulses. Key findings include significant roughness reduction, hierarchical patterning with ps pulses, and improved homogeneity. A cost function is developed for
Ignacio Tabares +7 more
wiley +1 more source
Simulation and Mechanical Properties of Fine-Grained Heat-Affected Zone Microstructure in 18CrNiMo7-6 Steel. [PDF]
Materials (Basel), 2022 Vuherer T +4 more
europepmc +1 more source
Simulation of Heat Affected Zone in X60 Steel
Insights in Mining Science & Technology, 2020 Ines Hamdi +2 more
openaire +2 more sources