Results 151 to 160 of about 262,009 (305)
Cathodic Cage Plasma Deposition of Nanostructured Cu–Fe–Se Coatings on Poly(methyl Methacrylate)
Nanostructured Cu–Fe–Se coatings are deposited on PMMA by a modified cathodic cage plasma process, enabling low‐temperature deposition on polymer substrates. A transition from discontinuous to compact morphology is observed with temperature, with optimal properties at 200°C, where improved CuFeSe2‐type bonding, lowest sheet resistance, and favorable ...
V. S. S. Sobrinho +8 more
wiley +1 more source
Simultaneous Heat and Mass Transfer in a Wetted Heat Exchanger, Part I: Experiments
Using an induced open-loop wind tunnel and a full cone water spray nozzle, the performance of a brazed aluminum heat exchanger with louvered fins is studied experimentally for wet conditions.
Jacobi, Anthony M. +3 more
core +1 more source
Experimental Study on Flow Boiling Heat Transfer of Zeotropic Mixture R290/R601a in a Mini-Channel
The flow boiling heat transfer characteristics of zeotropic mixture R290/R601a in a horizontal mini-channel with an inner diameter of 2 mm were experimentally studied.
Dechang Wang +4 more
core +1 more source
This study reports the development of antibacterial ceramic scaffolds derived from natural bovine bone. The bones were processed through sequential boiling and hydrogen peroxide treatment to remove organic matter, producing porous, mineral‐rich scaffolds.
Mohamad Hassan Taherian +6 more
wiley +1 more source
Numerical investigation on flow, heat and mass transfer performance of fractional Oldroyd-B hybrid nanofluid as a coolant for power battery. [PDF]
Xu X.
europepmc +1 more source
Vapour absorption refrigeration systems (VARS) has regained the attention due to their potential for renewable/waste heat utilization. To improve the efficiency of these systems, it becomes obligatory to make component level studies on processes. In this
Pasupathy, Balamurugan, Annamalai, Mani
core +1 more source
A distinct semi‐confined inner‐tube chemical vapor deposition geometry enables reproducible, large‐area growth of phase‐pure 2D β′‐In2Se3 from InI + Se precursors. Engineering local vapor transport and optimizing precursor delivery and temperature–time conditions yield uniform continuous films.
Dasun P. W. Guruge +8 more
wiley +1 more source
A Heat and Mass Transfer Model of Peanut Convective Drying Based on a Two-Component Structure. [PDF]
Chen P +7 more
europepmc +1 more source
Aluminum and nitride coatings are used in industry because they are hard, resist wear, and protect against oxidation. Adding boron can improve friction behavior and other properties. This study tests coatings on surfaces with different finishes. Results show smoother surfaces perform better, while rough ones wear faster, although coatings can reduce ...
Adrián Claver +9 more
wiley +1 more source
MHD heat and mass transfer of a ternary hybrid nanofluid over a rotating sphere. [PDF]
Obalalu AM +4 more
europepmc +1 more source

