Results 191 to 200 of about 2,060,902 (303)

Impacts of lateral conductive heat flow on ground temperature and implications for permafrost modeling. [PDF]

Sci Rep
Zhang Y, Hong G, Bonney MT.
europepmc   +1 more source

Characterization of Nitinol Produced by Laser Powder Bed Fusion for Mechanical Metamaterial Applications

Advanced Engineering Materials, EarlyView.
Stabilization of L‐PBF Ni50.7Ti49.3 under low‐cycle loading was investigated. Recoverable strain after cycling was dependent on the amount of applied load. Recovery ratio was 53.4% and 35.1% at intermediate and high load, respectively. The maximum total strain reached 10.3% at a high load of 1200 MPa.
Ondřej Červinek, Jakub Hurník, Miroslav Šmíd, Ondřej Zobač, Melanie Todt, Daniel Koutný   +5 more
wiley   +1 more source

Retraction notice to "Cattaneo-Christov heat flow model at mixed impulse stagnation point past a Riga plate: Levenberg-Marquardt backpropagation method" [Heliyon 9 (2023) e22765]. [PDF]

Heliyon
Hussain S, Islam S, Nisar KS, Zahoor Raja MA, Shoaib M, Abbas M, Saleel CA.   +6 more
europepmc   +1 more source

Heat flow measurements

, 2015
openaire   +1 more source

EBSD Study of Creep‐Induced Lattice Misorientation in MgO‐Particle‐Reinforced Austenitic Steel Composites

Advanced Engineering Materials, EarlyView.
Creep experiments at 900°C on coarse‐grained steel‐ceramic composites containing recycled magnesia reveal that higher ceramic volume fractions significantly enhance the creep resistance. Detailed EBSD investigations identify subgrain formation in the steel matrix as the dominant deformation mechanism.
Moritz Müller, Amaya Compart, Mahnaz Mehdizadehlima, Serhii Yaroshevskyi, Christos G. Aneziris, Horst Biermann, Anja Weidner   +6 more
wiley   +1 more source

Study of Heat Flow at Substrate during Sputtering of Copper-Titanium Sandwich Target. [PDF]

Materials (Basel)
Shapovalov VI, Sharkovskii DS.
europepmc   +1 more source

Reduction of Oxide Inclusions During the High‐Frequency Welding of Steel via a Nonthermal Ar/H2 Plasma Jet

Advanced Engineering Materials, EarlyView.
High‐frequency (HF) welding of steel is limited by oxide inclusions that degrade weld quality. This study demonstrates, for the first time, the integration of a nonthermal Ar/H2 dielectric barrier discharge (DBD) plasma jet into HF welding. Local plasma treatment provides effective shielding and in‐situ oxide reduction, resulting in markedly fewer and ...
Viktor Udachin, Lienhard Wegewitz, René Gustus, Henning Wiche, Wolfgang Maus‐Friedrichs   +4 more
wiley   +1 more source

A nanoscale photonic thermal transistor for sub-second heat flow switching. [PDF]

Nat Commun
Lim JW, Majumder A, Mittapally R, Gutierrez AR, Luan Y, Meyhofer E, Reddy P.   +6 more
europepmc   +1 more source

Handbook of Establishing and Maintaining Oxygen‐Free Atmospheres

Advanced Engineering Materials, EarlyView.
This study presents a practical framework for creating oxygen‐free atmospheres at ambient pressure using silane‐doped inert gases. The results show that ultra‐low oxygen levels and strongly reduced water content can be achieved through controlled silane dosing, drying systems, and sensor monitoring.
Sascha Jan Zimmermann, René Gustus, Lienhard Wegewitz, Wolfgang Maus‐Friedrichs   +3 more
wiley   +1 more source

Heat Flow Estimation in Polymer Films during Orientational Drawing at the Local Heater. [PDF]

Polymers (Basel)
Myasnikova L, Kurakin Y, Hilarov V, Marikhin V, Narykova M, Ivan'kova E.   +5 more
europepmc   +1 more source