Results 171 to 180 of about 33,872 (262)
Heat transfer and flow characteristics of a plate-fin heat sink equipped with copper foam and twisted tapes. [PDF]
Nilpueng K, Kaseethong P, Wongwises S.
europepmc +1 more source
We present a novel AI‐integrated implantation‐on‐chip platform that enables mimicking and monitoring the maternal–fetal interactions at the early phases of human embryo implantation with high spatiotemporal resolution. The complexity of the trophoblast invasion process was addressed by conducting the analysis at global (rate of invasion) and local ...
Joanna Filippi +12 more
wiley +1 more source
Masked divalent yttrium and gadolinium dinitrogen complexes mediate the fragmentation of white phosphorus, converting P4 into discrete dimetallic complexes of [P4]2– and [P2]2– ligands, and an unprecedented monatomic P2– radical ligand. Structural, spectroscopic, magnetic, and DFT studies reveal insight into the bonding between these unusual Pn units ...
Arpan Mondal, Richard A. Layfield
wiley +2 more sources
Metaheuristic aided structural topology optimization method for heat sink design with low electromagnetic interference. [PDF]
Al Ali M +6 more
europepmc +1 more source
Pre‐Curved Everting Robots With Embedded Steering Intelligence Fabricated by CO2 Laser Welding
Design and experimental demonstration of a laser welded growing robot for anatomically guided navigation. The robot follows an aortic arch phantom entering the branchiocephalic branch through steering by design. The figure shows the physical phantom setup, CAD defined weld geometry and full robot eversion.
Brandon Saldarriaga +5 more
wiley +1 more source
A heterogeneous photocatalytic system has been developed that enables the dehydrogenative decarbonylation of primary alcohols under visible light using highly dispersed oxidic iron sites supported on aryl‐modified graphitic carbon nitride (Fe@f–gC3N4).
Jun Hu +11 more
wiley +2 more sources
Influence of Heat Sink on the Mold Temperature of Gypsum Mold Used in Injection Molding. [PDF]
Lin CC, Chen KC, Yeh HC.
europepmc +1 more source

