Results 111 to 120 of about 147,924 (303)
V2:Performance of the solid deuterium ultra-cold neutron source at the pulsed reactor TRIGA Mainz
, 2014 The performance of the solid deuterium ultra-cold neutron source at the pulsed reactor TRIGA Mainz with a maximum peak energy of 10 MJ is described. The solid deuterium converter with a volume of V=160 cm3 (8 mol), which is exposed to a thermal neutron ...
Beck, M. +9 more
core +1 more source
Advanced Engineering Materials, EarlyView.Stabilization of L‐PBF Ni50.7Ti49.3 under low‐cycle loading was investigated. Recoverable strain after cycling was dependent on the amount of applied load. Recovery ratio was 53.4% and 35.1% at intermediate and high load, respectively. The maximum total strain reached 10.3% at a high load of 1200 MPa.
Ondřej Červinek +5 more
wiley +1 more source
Potential use of ceramic coating as a thermal insulation on cooled turbine hardware [PDF]
An analysis was made to determine the potential benefits of using a ceramic thermal insulation coating of calcia-stabilized zirconia on cooled engine parts. The analysis was applied to turbine vanes of a high temperature and high pressure core engine and
Liebert, C. H., Stepka, F. S.
core +1 more source
Advanced Engineering Materials, EarlyView.Creep experiments at 900°C on coarse‐grained steel‐ceramic composites containing recycled magnesia reveal that higher ceramic volume fractions significantly enhance the creep resistance. Detailed EBSD investigations identify subgrain formation in the steel matrix as the dominant deformation mechanism.
Moritz Müller +6 more
wiley +1 more source
EnergiesDespite a growing body of research on supercritical carbon dioxide (SCO2) heat transfer in microchannels, comprehensive reviews remain scarce. Existing studies predominantly focus on isolated experiments or simulations, yielding inconsistent findings and
Lianghui Guo +8 more
doaj +1 more source
Experimental investigation of forced convection of water/EG-Al2O3 nanofluids inside horizontal tube
E3S Web of Conferences, 2018 In this paper, forced convection of water/EG-Al2O3 nanofluids inside horizontal stainless steel tube is studied experimentally. As base fluid served water/EG mixture of two ratios (60:50 and 50:50).
Cieśliński Janusz T. +1 more
doaj +1 more source
Using infrared thermography for monitoring thermal efficiency of buildings - case studies from Nottingham Trent University [PDF]
, 2010 Global warming and the continuous increase of energy cost are driving the need for reducing energy consumption. Buildings are responsible for approximately 50% of the UK energy consumption.
Al-Habaibeh, A +4 more
core
Oxide‐Free Titanium Coatings by Wire Arc Spraying in a Silane‐Doped Inert Atmosphere
Advanced Engineering Materials, EarlyView.A silane‐doped argon atmosphere enables the production of oxide‐free titanium coatings via twin‐wire arc spraying at ambient pressure. This innovative approach eliminates residual oxygen, creating process conditions that prevent oxidation and nitride formation.
Manuel Rodriguez Diaz +4 more
wiley +1 more source
On the role of the Knudsen layer in rapid granular flows
, 2007 A combination of molecular-dynamics simulations, theoretical predictions, and previous experiments are used in a two-part study to determine the role of the Knudsen layer in rapid granular flows.
Bird +15 more
core +1 more source
Advanced Engineering Materials, EarlyView.Disordered (Fe50Co50)1−xPtx thin films exhibit a pronounced anomalous Nernst effect (ANE) with a strong composition dependence on both rigid and flexible substrates. The transverse thermoelectric response peaks near 22.5 at.% Pt, accompanied by enhanced αxy/σxy scaling, thermal transport, and ANE sensitivity.
Mojtaba Mohammadi +2 more
wiley +1 more source