Results 51 to 60 of about 852,733 (217)
Advanced Engineering Materials, EarlyView.CT‐based finite element simulations combined with in situ X‐ray computed tomography are used to analyze insert pull‐out in nickel‐coated polymer foams. Despite variations in material parameters, deformation consistently concentrates within a narrow annular region around the insert.
Yannik Bautz +4 more
wiley +1 more source
New Shop Floor Control Approaches for Virtual Enterprises [PDF]
The virtual enterprise paradigm seems a fit response to face market instability and the volatile nature of business opportunities increasing enterprise’s interest in similar forms of networked organisations.
José Barata, Luís Ribeiro
core
Rapidly Solidified High‐Strength Invar 36 Prepared by Planar‐Flow Melt Spinning
Advanced Engineering Materials, EarlyView.The Invar 36 alloy was rapidly solidified using the planar‐flow melt‐spinning technique. Ribbon samples with thicknesses ranging from 20 to 160 mm were produced. As the grain size of the ribbon decreased to sub‐micron levels, the hardness increased by more than 2 times.
Bekir Akgül, Mehmet Kul
wiley +1 more source
MULTIAGENT SYSTEMS FOR SHOP FLOOR ARHITECTURE MANAGEMENT [PDF]
The paper presents the problem of shop floor agility. In order to cope with the disturbances and uncertainties that characterise the current business scenarios faced by manufacturing companies, the capability of their shop floors needs to be improved ...
Dan FLOROIAN
core
Advanced Engineering Materials, EarlyView.Near‐surface deuterium enrichment profiles for different microstructural types of TiAl after exposure at 700 °C in a heavy water‐containing environment. The deuterium levels are significantly higher than expected from natural occurrence, indicating that the heavy water dissociated during the exposure treatment and entered the specimens.
Jonathan D. H. Paul +5 more
wiley +1 more source
Advanced Engineering Materials, EarlyView.Additive manufacturing introduces pronounced microstructural and crystallographic anisotropy in Ni‐based superalloys, resulting in orientation‐dependent creep deformation and damage. This review identifies the key microstructural origins of creep anisotropy, examines their influence on dominant deformation mechanisms, and highlights processing ...
Chandan Kumar +3 more
wiley +1 more source
Does Order Negotiation Improve The Job-Shop Workload Control? [PDF]
Work flows in a job-shop are determined not only by the release load and the time between release factors, but also by the number of accepted orders.
M. Rosário Moreira, Rui Alves
core
Elastohydrodynamic film thickness model for heavily loaded contacts [PDF]
, 1973 An empirical elastohydrodynamic (EHD) film thickness formula for predicting the minimum film thickness occurring within heavily loaded contacts (maximum Hertz stresses above 150,000 psi) was developed.
Zaretsky, E. V. +2 more
core
Laser‐Induced Graphene from Waste Almond Shells
Advanced Functional Materials, EarlyView.Almond shells, an abundant agricultural by‐product, are repurposed to create a fully bioderived almond shell/chitosan composite (ASC) degradable in soil. ASC is converted into laser‐induced graphene (LIG) by laser scribing and proposed as a substrate for transient electronics.
Yulia Steksova +9 more
wiley +1 more source
Contact fatigue of heavily loaded friction pairs strengthened by industion sureacing
, 1992 The scientific principles of the friction fatigue of the surfacing materials under the contact vulnerability to damage of the heavily loaded friction pairs were developed. The main regulatiries of wearing were determined.
Kolotienko Cergey Dmitrievich
core