Results 21 to 30 of about 21,723,556 (266)

Evaluation of E-waste processing through secondary copper smelting [PDF]

open access: yes, 2016
This presentation will report the processing of e-waste and extraction of the valuable metals through secondary copper smelting route (black copper smelting), as shown in Figure 1. The rationale for choosing the selected route will be explained.
Reuter, Markus   +9 more
core   +1 more source

The opportunities to combine electronic functions at high temperature

open access: yes, 2022
In this talk a short introduction into CMOS on SIMOX technology will be given. As an example for the advantages of this technology the temperature behaviour of the CMOS devices and the basic digital cells will be shown.
Burbach, G.
core   +1 more source

Effect of solution cooling methods on properties and residual stress of GH4096 alloy

open access: yesJournal of Aeronautical Materials, 2022
In order to ensure the main mechanical properties of GH4096 alloy, reduce the internal residual stress of forgings for thin-walled parts and improve the dimensional control accuracy of parts machining, the effect of air cooling (AC), wind cooling (WC ...
BAI Yunrui   +5 more
doaj   +1 more source

Rate-Determining Steps of Oxygen Surface Exchange Kinetics on Sr2Fe1.5Mo0.5O6−δ

open access: yesEnergies, 2020
The oxygen surface kinetics of Sr2Fe1.5Mo0.5O6−δ was determined using the 16O2/18O2 isotope exchange method with gas phase analysis at 600−800 °C.
Denis A. Osinkin   +5 more
doaj   +1 more source

Electrical Conductivity of Thin Film SrTi0.8Fe0.2O3−δ-Supported Sr0.98Zr0.95Y0.05O3−δ Electrolyte

open access: yesCeramics, 2022
Thin films of Sr0.98Zr0.95Y0.05O3−δ (SZY) electrolyte were grown on porous supporting SrTi0.8Fe0.2O3−δ electrodes by the chemical solution deposition method from a low-viscous solution of inorganic salts. The films were characterized by X-ray diffraction
Adelya Khaliullina   +2 more
doaj   +1 more source

Electrodeposition of aluminum-doped thin silicon films from a KF-KCl-KI-K2SiF6-AlF3 melt [PDF]

open access: yesJournal of the Serbian Chemical Society, 2021
The regularities of silicon and aluminum co-deposition on glassy carbon from KF–KCl (2:1)–75 mol % KI–0.15 mol % K2SiF6–(up to 0.15 mol %) AlF3 melts at 998 K were studied by cyclic voltammetry, chronoamperometry, scanning electron microscopy, atomic ...
Laptev Michael V.   +5 more
doaj   +1 more source

Transport Properties of Film and Bulk Sr0.98Zr0.95Y0.05O3−δ Membranes

open access: yesApplied Sciences, 2020
In electrode-supported solid oxide fuel cells (SOFCs) with a thin electrolyte, the electrolyte performance can be affected by its interaction with the electrode, therefore, it is particularly important to study the charge transport properties of thin ...
Adelya Khaliullina   +2 more
doaj   +1 more source

Silicon electrodeposition from chloride-fluoride melts containing K2SiF6 and SiO2 [PDF]

open access: yesJournal of the Serbian Chemical Society, 2017
Silicon electrodeposition on glassy carbon from the KF-KCl-K2SiF6, KF-KCl-K2SiF6-KOH and KF-KCl-K2SiF6-SiO2 melts was studied by the cyclic voltammetry.
Zhuk Sergey I.   +5 more
doaj   +1 more source

High temperature 0.35 micron Silicon-on-Insulator CMOS technology

open access: yes, 2022
S.254-258Silicon-on-Insulator (SOI) is the most commonly used technology for integrated circuits capable of operating at high temperature. Due to the efficient reduction of leakage current paths much higher operation temperatures are achievable with SOI ...
Kappert, Holger   +5 more
core   +1 more source

In situ synthesis, structural chemistry and vibrational spectroscopy of Zn-doped Ca5Mg4(VO4)6

open access: yesChimica Techno Acta, 2022
The phase formation of the solid solution Ca5Mg4–xZnx(VO4)6 (0≤x≤4) was studied in situ using differential scanning calorimetry and high-temperature X-Ray powder diffraction (XRPD). XRPD analysis shows the appearance of unavoidable secondary pyrovanadate
Anna S. Tolkacheva   +5 more
doaj   +1 more source

Home - About - Disclaimer - Privacy