Results 131 to 140 of about 109,202 (281)
Analytic auxiliary mass flow to compute master integrals in singular kinematics
The computation of master integrals from their differential equations requires boundary values to be supplied by an independent method. These boundary values are often desired at singular kinematical points.
Gaia Fontana +2 more
doaj +1 more source
Microsphere Autolithography—A Scalable Approach for Arbitrary Patterning of Dielectric Spheres
MicroSphere Autolithography (µSAL) enables scalable fabrication of patchy particles with customizable surface motifs. Focusing light through dielectric microspheres creates well defined, tunable patches via a conformal poly(dopamine) photoresist. Nearly arbitrary surface patterns can be achieved, with the resolution set by the index contrast between ...
Elliott D. Kunkel +3 more
wiley +1 more source
Quantifying Spin Defect Density in hBN via Raman and Photoluminescence Analysis
An all‐optical method is presented for quantifying the density of boron vacancy spin defects in hexagonal boron nitride (hBN). By correlating Raman and photoluminescence signals with irradiation fluence, defect‐induced Raman modes are identified and established an relationship linking optical signatures to absolute defect densities. This enables direct
Atanu Patra +8 more
wiley +1 more source
QCD phenomenology with infrared finite SDE solutions
Recent progress in the solution of Schwinger-Dyson equations (SDE), as well as lattice simulation of pure glue QCD, indicate that the gluon propagator and coupling constant are infrared (IR) finite. We discuss how this non-perturbative information can be
Natale, A. A.
core
Photomultiplication organic photodetectors (PM OPDs) are an attractive strategy for health‐monitoring. Here, PM‐OPDs are reported with a specific detectivity of 5.7 × 1012 Jones and external quantum efficiency values of 3500% under −10 V. The dynamics of carrier trapping in these devices are elucidated through trap selective spectroscopical techniques.
Marie Houot +9 more
wiley +1 more source
Fe─NC porous oxygen reduction electrocatalysts are prepared employing a 2,4,6‐Triaminopyrimidine‐based porous organic polymer, a Mg2+ Lewis acid, and a low‐temperature cation exchange protocol. Using the polymer precursor achieves high pyrolysis yields and results in atomically dispersed FeNx sites. The resulting catalysts feature hierarchical porosity
Eliot Petitdemange +11 more
wiley +1 more source
Three‐dimensional Antimony Sulfide Based Flat Optics
This work presents the development of a grayscale electron beam lithography (g‐EBL) method for fabricating antimony trisulfide (Sb2S3) nanostructures with customizable 3D profiles. The refractive index of g‐EBL patterned Sb2S3 is determined based on the synergy of genetic algorithm and transfer matrix method.
Wei Wang +18 more
wiley +1 more source
Towards numerical two-loop integrand reduction
We present a method for the integrand-level reduction of two-loop helicity amplitudes in both d = 4 – 2ϵ and d = 4 dimensions. The amplitude is expressed in terms of a set of Feynman integrals and their coefficients that depend on the external kinematics.
Giuseppe Bevilacqua +3 more
doaj +1 more source
A FeN4─O/Clu@NC‐0.1Ac catalyst containing atomically‐dispersed FeN4─O sites (medium‐spin Fe2+) and Fe clusters delivered a half‐wave potential of 0.89 V for ORR and an overpotential of 330 mV at 10 mA cm−2 for OER in 0.1 m KOH. When the catalyst was used in a rechargeable Zn–air battery, a power density of 284.5 mW cm−2 was achieved with excellent ...
Yongfang Zhou +8 more
wiley +1 more source
Isolated photon cross section and resummation of the logarithms of the cone radius
The cone isolation criterion used in large-pt photon experiments generates logarithms of the cone radius in the theoretical cross sections. When a small radius is used, unitarity is violated as the inclusive cross section is smaller than the isolated one.
M. Fontannaz, J. Ph. Guillet
doaj +1 more source

