Results 51 to 60 of about 34,963 (304)
Development of Inductive Current Transformer 400/5/1 of Class 0.2S for Frequency Range 50 Hz–5 kHz
SensorsThis paper is devoted to the development of a window-type inductive current transformer (iCT) with a rated primary current equal to 400 A and two secondary windings with rated currents of 5 A and 1 A. Its novelty concerns the presentation of this process
Michal Kaczmarek, Blazej Pacholczyk
doaj +1 more source
Evaluation of coated QCM for the detection of atmospheric ozone [PDF]
, 2011 A coated acoustic wave sensor has been developed to selectively detect atmospheric ozone. The selective detection has been assessed using a variety of coatings: beeswax, gallic acid, indigo carmine, polybutadiene, potassium iodide and sodium nitrite ...
Muller, JBA +11 more
core +1 more source
Advanced Engineering Materials, EarlyView.Coarse‐grained (left) and atomistic (right) models of the shape memory polymer ESTANE ETE 75DT3 are shown schematically. The two representations bridge molecular detail and mesoscopic description. Both models capture shape memory behavior, linking segmental mobility and conformational relaxation of anisotropic chains to macroscopic recovery, and ...
Fathollah Varnik
wiley +1 more source
IEEE Access, 2020 The novelty of the paper contributes to the increase of the reliability of the methods used for evaluation of the inductive CTs accuracy of transformation of the distorted current.
Michal Kaczmarek, Ernest Stano
doaj +1 more source
AC Distributed Winding with Low Higher Spatial Harmonics Content in Mmf Distribution
, 2023 This paper presents a new winding with a low higher spatial harmonics content. This winding enables the elimination of the fifth harmonic, as the most significant, in three-phase winding and the third harmonic in two-phase symmetrical winding.
Jan Staszak
core +1 more source
Exciton Binding Energy of Phosphorescent Emitter Molecules in Organic Light‐Emitting Diodes
Advanced Functional Materials, EarlyView.Energy level alignment is key to efficient OLED design, yet determining LUMO energies remains challenging. A methodology based on field‐induced dissociation and kinetic Monte Carlo simulations is presented to extract LUMO energies of iridium‐based phosphorescent emitters from their exciton binding energy.
Hiroki Tomita +6 more
wiley +1 more source
Advanced Functional Materials, EarlyView.A printed superparamagnetic nanoparticle‐based flux guide enables the realization of a hysteresis‐free three‐axis magnetic sensor. This innovative architecture efficiently redirects out‐of‐plane fields to planar sensing elements, facilitating simultaneous vector detection without complex reset protocols.
Changyeop Jeon +10 more
wiley +1 more source
EnergiesAccording to standards, the harmonic content should be less than 5% at the time of calibration, while the calibration index proposed in this paper stipulates that the primary current amplitude of 1%~120% of the full range of the accuracy level reaches 0 ...
Can Ding +3 more
doaj +1 more source
Biosensors, 2016 We developed an impedance quartz crystal microbalance (QCM) approach with the ability to simultaneously record mass changes and calibrated energy dissipation with high sensitivity using an impedance analyzer.
Manuel Kasper +5 more
doaj +1 more source
New Approach for Voltage Drop Estimation in the Busbars of Workshop Networks at Higher Current Harmonics Influence [PDF]
Problems of the Regional Energetics, 2019 The presence of higher current harmonics has a negative impact on the efficiency and reliability of the elements of network. Higher current harmonics can lead to significant increases of resistance, voltage drop and active losses in busbar, also to ...
Kotsur M.I. +3 more
doaj +1 more source