Results 11 to 20 of about 21,045 (295)
Metals, 2020 Climate targets set by the EU, including the reduction of CO2, are leading to the increased use of lightweight materials for mass production such as press hardening steels.
Mirko Bach +5 more
doaj +2 more sources
Effect of initial blank temperature in hot press forming towards 22MnB5 springback failure [PDF]
Journal of Mechanical Engineering and Sciences, 2019 The springback failure of ultra-high strength boron steel (22MnB5) in hot press forming (HPF) process was characterized under bending and membrane conditions.
C. H. Ng +5 more
doaj +2 more sources
Investigation of Usibor 1500 Formability in a Hot Forming Operation
Medžiagotyra, 2013 The hot forming process included heating metals to a temperature in the austenite range, transferring the austenitized sheet from the furnace to a press, forming and simultaneously quenched.
Hande GÜLER
doaj +5 more sources
Metals, 2018 In aerospace and automotive industries, hot press forming (HPF) technology is widely used for rapid and precise deformation of the complex sheet metal component, where the fracture behavior has always been a focused problem.
Ronglei Fan +3 more
doaj +2 more sources
Hydrogen Absorption and Desorption Behavior on Aluminum-Coated Hot-Stamped Boron Steel during Hot Press Forming and Automotive Manufacturing Processes. [PDF]
Materials (Basel), 2021 Our study mainly focused on diffusible hydrogen in aluminum–silicon-coated hot-stamped boron steel during a hot press forming process and in pre-treatment sequential lines of the automotive manufacturing process using a thermal desorption spectroscopy ...
Kim HJ +5 more
europepmc +2 more sources
Effect of the Fabrication Technique on Compressive Properties of Cu-PTFE Composites
Advances in Materials Science and Engineering, 2021 In this paper, the effect of manufacturing methods on the compressive properties of Cu-PTFE (polytetrafluoroethylene) composites was investigated. Two types of specimens were prepared through different manufacturing methods (extrusion forming and hot ...
Xuezhi Tang +3 more
doaj +1 more source
Metals, 2023 Additive technologies are now widely used for the production of complex precise parts and have high potential for the production of forming dies. In this work, hot-forming dies optimized for additive manufacturing were developed and produced with wire ...
Artem Alimov +4 more
doaj +1 more source
In-Depth Comparison of an Industrially Extruded Powder and Ingot Al Alloys
Metals, 2020 An industrial press was used to consolidate compacted aluminum powder with a nominal diameter in the range of 1 µm. Direct and indirect hot-extrusion processes were used, and suitable process parameters were determined from heating conditions, ram speeds
David Bombač +4 more
doaj +1 more source
A Study on the Analysis for Upper Seat Track of Automobile Using 1180 MPa Ultra-High Strength Steel [PDF]
한국정밀공학회지, 2017 As emission regulation of vehicles is being reinforced globally, the current requirement of the automobile industry are innovative green technologies that reduce the weight of the vehicle, thereby improving fuel consumption and the amount of exhaust gas ...
Choon-Man Lee +3 more
doaj +1 more source
Materials Research Express, 2022 In the pre-forming process of uncured prepreg laminates with hot press, the compaction stress is an important parameter that affects the performance and quality of the final product.
Zhefu Li +5 more
doaj +1 more source